Manual Operation; Starting Programs Or Stations Manually - Toro GreenKeeper 212 User Manual

Manual Operation

Manual operation enables the automatic watering pro-
grams or selected stations assigned to the program to be
started manually. During operation, temporary changes
can be made to increase or decrease the station run
time, step through the station sequence and pause or
stop watering using the "Watering Control Features"
described on page 32. Upon completion of the manual
watering operation, the controller will return to the Auto-
matic mode.
Starting Programs and/or Stations Manually
You may operate all stations or selected stations in each
program. Watering programs can be started individually or
set to start in order. When one program finishes the next
selected program will operate.
Ensure the control dial is in the
Position the
PROGRAMS
you wish to start.
Choose one of the following manual operations:
• To operate the selected program with all
assigned stations, press the
button two times to begin watering.
• To operate only selected stations, press the
button, then press the +/
MANUAL START
to select the flashing zone number, or press the
–/ button to skip the zone number. Continue
OFF
selecting or omitting zones in this manner. When
only the desired zones are displayed, press the
button again to begin watering.
MANUAL START
position.
RUN
switch to select the program
MANUAL START
button
ON
Flashing
1
Example: Program A is operating. Program B will start
when program A is finished.
4. To select additional programs, repeat steps
Note: Additional programs set to start will operate
one at a time in alphabetical order. Each program
letter will be displayed as it is selected. The program
currently operating is indicated by the flashing pro-
gram letter.
Flashing
PGM A B
1 2 3 4 5 6
3
3
2 3
and .
31