Resetting The Controller Memory; To Reset The Permanent Memory; To Clear The Memory - Toro GreenKeeper 212 User Manual

Resetting the Controller Memory

The GreenKeeper 212 program memory can be reset to
the permanent program values or cleared completely at
any time without removing power.
Resetting the permanent program erases all user input
and replaces it with the permanent program values.
Clearing the program memory sets all program values to
Off (i.e., no active days, program start times or station
run times). You may find that this simplifies programming
the controller if your watering requirements are quite
different than the permanent values.
Note: When power is first applied, the GreenKeeper 212
will always reset to the permanent program values.
To Reset the Permanent Program (Figure 4)
Turn the control dial to the
be displayed.
Press the +/ and –/
ON
until CLR is displayed.
Return the control dial to the
To Clear the Memory (Figure 5)
Turn the control dial to the
be displayed.
Press the +/ and
ON NEXT
until CLR 0 is displayed.
Return the control dial to the
position. OFF will
OFF
buttons at the same time
OFF
position.
RUN
position. OFF will
OFF
buttons at the same time
position.
RUN
Figure 4
2
3
1
Figure 5
2
3
1
2
2
15