Brother CE7070PRW Operation Manual page 26

KNOWING YOUR SEWING MACHINE — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
d As shown, press down on the spool pin lever
with your finger.
The spool pin swings up.
CAUTION
● Do not grab the bar to raise the spool pin,
otherwise, the spool pin may bend or break.
e Remove the spool cap.
a Spool pin
b Spool cap
CAUTION
● Be sure to raise the spool pin before use. If the
spool of thread is in the wrong place, or is set
incorrectly, the thread may tangle on the
spool pin and cause the needle to break.
24
f Fully insert the spool for the upper thread
onto the spool pin.
Slide the spool onto the pin so that the spool is
horizontal and the thread unwinds to the front
at the bottom.
g Slide the spool cap onto the spool pin.
With the slightly rounded side of the spool cap
positioned toward the left, slide the spool cap
onto the spool pin as far as possible to the right
so that the spool is moved to the right end of
the spool pin.
CAUTION
● If the spool or the spool cap is not positioned
correctly, the thread may become tangled
around the spool pin or the needle may break.
● Three spool cap sizes are available, allowing you
to choose a spool cap that best fits the size of
spool being used. If the spool cap is too small for
the spool being used, the thread may catch on
the slit in the spool or the needle may break.