Basic Stitching - Brother CE7070PRW Operation Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

BASIC STITCHING

Straight stitches are used for sewing plain seams. Three stitches are available for basic stitching.
Stitch Name
Left
Center
Triple
stretch stitch
*Do not use reverse stitching.
CAUTION
● Be sure to turn off the main power before replacing the presser foot. Otherwise, injuries may occur if
the foot controller or
Basic stitching
a Baste or pin together the fabric pieces.
b Attach zigzag foot "J".
c Select a stitch.
• For details, refer to "Selecting a stitch"
(page 37).
d Lower the needle into the fabric at the
beginning of the stitching.
e Start sewing.
• For details, refer to "Starting to sew"
(page 39).
• For details on sewing reverse/reinforcement
stitches, refer to "Sewing reinforcement
stitches" (page 40).
Pattern No.
J 00 00 00 00 00
J 01 01 01 01 01
J 02 02 02 02 02
(start/stop button) is accidentally pressed and the machine starts sewing.
Application
Basic stitching, sewing
00 00
gathers or pintucks, etc.
Attaching zippers, basic
01 01 stitching, and sewing
gathers or pintucks, etc.
Attaching sleeves, sew-
ing inseams, sewing
02 02
stretch fabrics and deco-
rative stitching
**Select a stitch width of 5.0 mm (3/16 inch) or less.
f When sewing is finished, cut the thread.
• For details, refer to "Starting to sew"
(page 39).
■ Changing the needle position
With the straight stitch (left needle position) and
the triple stretch stitch, the needle position can be
adjusted. Pressing the "+" side of the stitch width
adjustment key moves the needle to the right;
pressing the "–" side of the stitch width
adjustment key moves the needle to the left.
a Stitch width
b Stitch width adjustment key
c Left needle position
d Right needle position
Stitch Width Stitch Length
[mm (inch.)] [mm (inch.)]
Auto Auto
Manual Manual
0.0 (0) 2.5 (3/32)
**
Yes
0.0–7.0 0.2–5.0
( J )
(0–1/4) (1/64–3/16)
3.5 (1/8) 2.5 (3/32)
**
Yes
0.0–7.0 0.2–5.0
( J )
(0–1/4) (1/64–3/16)
0.0 (0) 2.5 (3/32)
**
Yes
0.0–7.0 1.5–4.0
( J )
(0–1/4) (1/16–3/16)
*
Rev.
Yes
*
Rev.
3
Yes
No Rfc.
47