Targus 100W Auto/Air Quick Start Manual

Power / Fault Indicator
This light will flash (blue color) if the
inverter encounters problems.
LED is ON
– Normal operation.
LED is flashing
– Low voltage
warning signal indicates the supply
voltage is low.
LED is OFF
– Unit is off and no
power is being output. Either the
inverter is not plugged into a powered
socket or it has gone into protection
mode due to overheating, overvoltage,
overloading or short circuit.
USB Output
(DC power only)
Electrical Ratings:
Input: 12-16Vdc
AC Output: 120Vac 60 Hz
(modified sinewave)
100W continuous (150W surge)
USB Output: 5Vdc 500mA
Typical Usage
This listing is for reference purpose only. Some
devices exceed the wattages listed. Before using the
device, please refer to the owner's manual for actual
wattage required.
Play Station 10 Watt
Cellular Phone Charger 25 Watt
Portable Color Printer 30 Watt
Hi-Fi 4 head Stero VCR 40 Watt
13" color TV 70 Watt
Notebook computer 50 Watt
CD player 85 Watt
Work Light 100 Watt
WARNINGS
Any electric appliance with the power consump-
tion beyond 100W is not allowed for usage.This
inverter is not recommended for use with
inductive loads, such as fluorescent lamps or
pumps and most heat generation equipment
such as hair dryers, coffee makers, irons, heaters
and toasters. Otherwise, permanent damage to
the unit and excessive overheating may result.
Features and specifications subject to change without notice. © 2006, Targus Group International, Inc. and Targus, Inc., Anaheim, CA 92806 USA.
100W Auto/Air®
Mobile Power Inverter
Slimline Style
AC output
Hypertronics to CLA auto/air adapter
DC In-Auto connector
DC In-Air connector (for airline compatibility, go to Web site below)
http://www.targus.com/
Press
DC
air
WARNINGS
If the external cable of this inverter is damaged, stop
using this and contact the authorized agent to replace it to
avoid hazard.
CAUTIONS
Regularly check input and output connections are tight.
Loose connections can generate harmful heat and / or
damage the inverter or power source.
hazard.

Quick Start Guide

Ventilation openings
WARNING
• Do not block or cover any louvered vents . Place
the inverter on a flat surface with good ventilation
between 0-35 o C and ideally 15-25 o C.
• Do not place the inverter on or near a heating
vent or any piece of heat generating equipment.
Keep inverter away from direct sunlight, if at all
possible.
• Do not allow water or other liquids to come into
contact with the inverter.
Fuse
CAUTIONS
This inverter is fitted with a spade type 32Vdc
15A fuse. Once the fuse blows, replace with a
same specification and type fuse. Usage of
another type fuse or metal wire will cause
abnormal overheating or even fire hazards.
Note: When replacing the fuse, please make sure that
all the electrical device(s) are turned off and the power
cables are unplugged. Make sure the fuse is replaced
correctly and before reconnecting the device(s).
DC
auto
Prevent shock
APV10US / 410-0571-001A