Camera; Motion - Digimerge Touch DH200 Series Instruction Manual

CAMERA

Figure 33.0 Camera options
To configure Camera options:
camera icon
1. Select a
2. For the selected camera configure the
following:
• COVERT: Select YES/NO. If YES, the camera
channel will be obscured from live viewing to
give the impression that no camera is
recording. Use this option if the display
monitor is in public view.
NOTE: The Covert channel will use the same
background color as a disconnected
camera. To change the background color,
see see "DISPLAY" on page 60.
• BRIGHTNESS, CONTRAST, COLOR: Adjust
from 0~100.
• TITLE: enter a name/title for the camera
• PTZ MODEL: Select the model of your
connected PTZ camera from the drop-down
menu
• PTZ ID: Enter your PTZ ID (PTZ ID should
match the camera channel to which you have
connected the PTZ camera)
3. Repeat steps 1~2 for any remaining cameras.
APPLY
4. Click and then
settings and close the window.
at the top of the window.
OK
to save your

MOTION

Figure 34.0 Motion options
To configure Motion options:
1. Under RECORD TIME, adjust the time from
10 300
~ seconds.
NOTE: The set recording time is applicable
to all channels.
2. Under CAMERA SELECT, select a camera icon.
3. Under SENSITIVITY, and adjust from
higher the number, the greater the sensitivity.
4. Under MOTION GRID,
click one of the grid
icons to apply a
motion grid to the
selected camera.
NOTE: Disabled
blocks are colored
grey
. Active blocks will
turquoise-colored
be
when motion is
detected.
5. Repeat steps 1~4 for any remaining cameras.
6. Click APPLY and then OK to save your settings
and close the window.
Remote Setup
1~20
. The
Figure 34.1 Motion icons
61