Record; Alarm - Digimerge Touch DH200 Series Instruction Manual

Using the Main Menu
+
• Press enable/disable motion sensitivity.
Disabled blocks are colored
turquoise-colored
blocks will be
is detected. Move an object in front of the
selected camera to test sensitivity and
enable/disable the appropriate blocks
-
• Press to exit the grid
• Press to select All/Clear
+
and then press
6. Press to save your
ENTER
settings. Press
CANCEL/ESC
to close remaining menu
windows.

RECORD

Configure recording parameters for
each channel.
Figure 15.0 Record menu
To configure recording settings:
1. Press to select a camera.
2. Press to select an option and the
+ -
press / to configure the following:
• USE: Select ON/OFF. If OFF, the selected
camera(s) will not record.
• QUALITY: Select LOW, MIDDLE, HIGH,
SUPER, and ULTRA.
• RATE: Select 1, 2, 3, 4, 5, 6, 7, 10, or 15 fps.
• AUDIO: Select ON/OFF. Audio capable
cameras or microphones are required for
audio recording.
• MOTION: Select ON/OFF. Motion Grid and
sensitivity must be configured in the Motion
menu. See "MOTION" on page 23.
24
grey . Active
when motion
Select ALL.
.
Clear.
3. Press to save your settings. Press
ENTER
to close remaining menu
CANCEL/ESC
windows.

ALARM

Configure recording parameters for
alarm recording.
NOTE: An external alarm device is not included
with the system.
Figure 16.0 Alarm menu
To configure alarm settings:
1. Under RECORD SETUP, press
select a camera. Press
+
option and press
following:
• USE: Select ON/OFF. If OFF, the selected
camera(s) will not record.
• QUALITY: Select LOW, MIDDLE, HIGH,
SUPER, and ULTRA.
• RATE: Select 1, 2, 3, 4, 5, 6, 7, 10, or 15 fps.
• AUDIO: Select ON/OFF. The number of audio
input channels varies by model.
• INPUT: Select N.O/
N.C.
to
to select an
-
/ to configure the
TIP!
When you have
configured settings for
one camera, press
to apply the settings for
the rest of the cameras!