Motion - Digimerge Touch DH200 Series Instruction Manual

Motion

Motion Detection must be applied to specific cameras. If you assign Motion Detection to a camera,
that camera will only record when a motion event is triggered. The camera enabled with Motion
Detection will have a
1
3
Figure 8.1 Motion assigned to channel 4 (4CH model shown)
A white number can also indicate that recording on a camera has been disabled. For
NOTE:
better security it is highly recommended to keep continuous recording for all cameras on at
all times. Use caution when assigning motion detection to specific cameras.
When motion is detected by the camera, the motion icon will appear, and the channel number will
turn (see figure 8.2).
RED
1
3
Figure 8.2 Motion was detected on camera 4 (4CH model shown)
Press the CANCEL/ESC button on the remote control, front panel, or Virtual Remote to
NOTE:
clear the motion icon.
If you assign motion detection to ALL cameras, the REC icon will not appear in the top-left
NOTE:
corner, but the "R" will remain in the status bar of the OSD.
number on the OSD (see figure 8.1).
WHITE
2
4
2
4
• In this example, motion
detection was assigned to
camera 4, so the channel
number is WHITE
• Continuous Recording
remains on channels 1~3
• In this example, motion was
detected on camera 4—the
motion icon appears and the
channel number turns RED
• Continuous Recording
remains on channels 1~3
Recording
17