Adjusting Leveling Feet; Attaching The Handwheel; Hex Nut - Sears Craftsman 113.248211 Owner's Manual

5. Use truss head bolts, Iockwashers, and hex nuts to
mount the two (2) rear legs to the basic saw assem-
bly. It may be necessary to slightly tilt the saw as-
sembly backwards in order to get the four (4) holes in
each corner of the saw to line up with the four (4)
holes in the top of each leg. Finger tighten nuts at
this time.
6. Attach t he four (4) lower stiffeners to the legs. Two (2)
truss head bolts, washers, and hex nuts are re-
quired to hold each end of a lower stiffener in place.
Only hand tighten hex nuts.
TRUSS HEAD BOLT-'-"--"
WASHER
LEG
i , HEX NUT
7. Go back with a 7_6wrench or socket and tighten all
hex nuts.
8. Carefully lift the saw into its normal position. It may
be necessary to have someone help you in order to
avoid damaging the saw.
STIFFENER
ADJUSTING LEVELING FEET
I WARNING: TO avoid injury from unexpected saw I
or work movement, leveling feet must be adjusted
so that saw does not rock.
To adjust leveling feet so the saw will sit properly:
1, Move saw to desired location.
2. Raise or lower leveling foot by turning it clockwise or
counterclockwise.
3. Tighten nuts to lock leveling foot in place.
ATTACHING THE HANDWHEEL
1. From loose parts bag find one (1) pan head screw
10-32 x 2and one (1) hex nut. Install the hand-
wheel. Reach inside the base to the back side of
the bevel mechanism and put the nut in place.
Hold the nut in place with a finger. Install the
screw through the center of the handwheel and
tighten with a phillips screwdriver.
2. Hotd the handle and pu!t the red release button
witil your finger to close the handle.
C,,Cf_,,
, ,'!.
i
13