Item Description Qty - Sears Craftsman 113.248211 Owner's Manual

BOTH MODELS
ATTACHING LEG SET
From the loose parts bag find the following hardware:
Item Description Qty.
A Truss Head Bolts 1/4-20 x 1/2........... 32
B Lockwashers External 1/4 ............. 32
C Hex Nuts 1/4-20 ...................... 32
From the loose parts find the following items:
D Leg Channel ........ . .............. 1
E Legs (with attached support brackets and
leveling feet) 4
F Lower Stiffeners .................... 4
B ¢
E* F_
*NOT SHOWN TO SCALE
,
1. Lay a piece of cardboard on the floor to keep from
scratching the saw.
2. Position the basic saw assembly on the floor as
shown below. The back cabinet of the saw should be
laying flat on the floor. It may be necessary to have
someone help you lift the saw.
SWITCH
FRONT
3, Mount the two front legs to the basic saw assembly
using truss head bolts, Iockwashers, and nuts.
Make sure that the four (4) holes in each corner of
the saw line up with the four (4) holes in the top of
each leg, At this time only put bolts through the sides
of the saw assemblynotthe front. Only fingertighten
nuts.
4,
Position the leg channel inside the legset as shown.
Fasten the channel piece, leg, and saw together
with two (2) truss headbolts on each side. The
threaded section of the bolts should point towards
the inside of the basic saw assembly Put a lock-
washer and hex nuton each bolt. Fingertighten nuts
at this time.
NUT 7_-_/
LOCKWASHER
FRONTLEGSAND
CHANNEL ARE
A3q-ACHED HERE
LEG
REAR LEGS ARE
3HED HERE
FLOOR
;CHANNEL
LEG
_ TRUSS t_,---HEAD
SCREW
Truss head screw, lockwasher, hex nut, and front channel p_ece
12