To Stop The Snow Thrower; To Control Snow Discharge; To Throw Snow; To Use Wheel Lockout Pin - Craftsman 536.887995 Operator's Manual

9 horsepower electric start dual stage
Table of Contents

Advertisement

Available languages

Available languages

[o_o)_l
The operation of any snow thrower can
result in foreign objects being thrown
into the eyes, which can result in se-
vere eye damage.
Always wear safety
glasses or eye shields while operating
the snow thrower.
We recommend standard safety
glasses or a wide vision safety mask for
over your glasses.
_b
ARNING: Read Owner's
Manual before operating
machine. Never direct dis-
charge toward bystanders. Stop the
engine before unclogging discharge
chute or auger housing and before
leaving the machine.
TO STOP YOUR
SNOW
THROWER
1. To stop throwing snow, release the
auger drive lever.
2. To stop the wheels, release the
traction drive lever,
3. To stop the engine, push the
throttle control lever to off and pull
out the ignition
key.
TO CONTROL
SNOW
DISCHARGE
1. Turn the chute control rod to set the
direction of the snow throwing.
2. Loosen the wing knob on the chute
deflector and move the deflector to
set the distance. Move the deflector
(Up) for more distance, (Down) for
less distance. Then tighten the
wing knob (See Figure 9).
Knob
the speed
you desire
by moving
the
speed
shifter
lever left into the ap-
propriate
notches
on the shift lever
plate:
Speeds
1,2-
Wet, Heavy
Speed 3 - Light
Speed
4 -Very
Light
Speed
5,6 - Transport
only
2.
Engage
the traction
drive lever (left
hand).
As the snow thrower
starts
to move,
maintain
a firm hold on the
handles,
and guide the snow throw-
er along the clearing
path.
Do not
attempt
to push the snow thrower.
3.
To move the snow thrower
back-
ward,
move the speed
shifter
lever
right into first or second
reverse
and
engage
the traction
drive lever (left
hand).
IMPORTANT:
Do not move
the speed
shifter
lever while
the traction
lever
is down.
TO THROW
SNOW
1. Push down the auger driver lever
(right hand).
2. Release to stop throwing snow.
TO USE WHEEL LOCKOUT PIN
The right hand wheel is secured to
the axle with a klick pin.
This unit
was shipped with this klick pin in the
locked position (through
wheel
hole). See Figure 10.
Figure 9
Klick Pin
HOW TO MOVE FORWARD AND
BACKWARD
1.
To shift, release
the traction
drive
lever
(left hand)
and move the
Locked
speed
shifter
lever to the speed
you
Position
desire.
Ground
speed
is deter-
mined
by snow
conditions.
Select
F 041037L
11
2-Wheel
Drive
Figure 10

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents