Netopia 2200 series Software User's Manual page 69

Configure
ATM Circuits: You can configure the ATM circuits and the number of Sessions. The IP
Interface(s) should be reconfigured after making changes here.
Available Encapsulation types:
PPP over Ethernet (PPPoE)
PPP over ATM (PPPoA)
RFC-1483 Bridged Ethernet
RFC-1483 Routed IP
None
Netopia Firmware Version 7 supports VPI/VCI autodetection by default. If VPI/VCI auto-
detection is enabled, the ATM Circuits page displays VPI/VCI = 0. If you configure a new
ATM VPI/VCI pair, upon saving and restarting, autodetection is disabled and only the
new VPI/VCI pair configuration will be enabled.
VPI/VCI Autodetection consists of eight static VPI/VCI pair configurations. These are 0/
35, 8/35, 0/32, 8/32, 1/35, 1/1, 1/32, 2/32. These eight VPI/VCI pairs will be cre-
ated if the Gateway is configured for autodetection. the Gateway does not establish a
circuit using any of these preconfigured VPI/VCI pairs, then you can manually enter a
VPI/VCI pair in the ATM Circuits page.
ATM Traffic Shaping: You can prioritize delay-sensitive data by configuring the Quality
of Service (QoS) characteristics of the virtual circuit. Click the
link.
Available Multiplexing types:
LLC/SNAP
VC muxed
ATM Traffic Shaping
69