Netopia 2200 series Software User's Manual page 142

Add, Edit, or delete exposed addresses options are active only if NAT is disabled on a WAN
interface. The hosts specified in exposed addresses will be allowed to receive inbound traf-
fic even if there is no corresponding outbound traffic.
• Start Address: Start IP Address of the exposed host range.
End Address: End IP Address of the exposed host range
•
Protocol: Select the Protocol of the traffic to be allowed to the host range from the pull-
•
down menu. Options are Any, TCP, UDP, or TCP/UDP.
• Start Port: Start port of the range to be allowed to the host range. The acceptable
range is from 1 - 65535
End Port: Protocol of the traffic to be allowed to the host range. The acceptable range
•
is from 1 - 65535
You can add more exposed addresses by clicking the
link. A list of previously configured exposed addresses appears.
142
Add more Exposed Addresses