Set Console Baud; Activating Licensed Features - Enterasys D2 D2G124-12P Cli Reference Manual

Mode
Switch command, read‐only.
Example
This example shows how to display all console settings:
D2(su)->show console
Baud
------
9600

set console baud

Use this command to set the console port baud rate.
Syntax
set console baud rate
Parameters
rate
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set the console port baud rate to 19200:
D2(su)->set console baud 19200

Activating Licensed Features

In order to enable the D2 advanced features, such as Policy, you must purchase and activate a
license key. If you have purchased a license, you can proceed to activate your license as described
in this section. If you wish to obtain a permanent or evaluation license, use the Enterasys
Customer Portal or contact the Enterasys Networks Sales Department.
Flow Bits StopBits
------- ---- ----------
Disable 8 1
Sets the console baud rate. Valid values are: 300, 600, 1200, 2400, 4800, 5760,
9600, 14400, 19200, 38400, and 115200.
Parity
------
none
set console baud
D-Series CLI Reference 2-27