Clear Dhcp Pool Host; Set Dhcp Pool Client-Identifier - Enterasys D2 D2G124-12P Cli Reference Manual

clear dhcp pool host

clear dhcp pool host
Use this command to remove the host IP address from a manual binding address pool.
Syntax
clear dhcp pool poolname host
Parameters
poolname
Defaults
None.
Mode
Switch command, read‐write.
Example
This example deletes the host IP address from the address pool named "manual1."
D2(rw)->clear dhcp pool manual1 host

set dhcp pool client-identifier

Use this command to configure the client identifier of the DHCP client and create an address pool
for manual binding. You can use either this command or the set dhcp pool hardware‐address
command to create a manual binding pool, but using both is not recommended.
Syntax
set dhcp pool poolname client-identifier id
Parameters
poolname
id
Defaults
None.
Mode
Switch command, read‐write.
Usage
The client identifier is formed by concatenating the media type and the MAC address. For
example, if the client hardware type is Ethernet and the client MAC address is 00:01:22:33:44:55,
then the client identifier configured with this command must be 01:00:01:22:33:44:55.
14-16 DHCP Server Configuration
Specifies the name of the address pool. Pool names may be up to 31
characters in length.
Specifies the name of the address pool. Pool names may be up to 31
characters in length.
Specifies the unique client identifier for this client. The value must be
entered in xx:xx:xx:xx:xx:xx format.