Packet Capture Commands
Packet Capture Commands
Note that packet capture filter is sampling only and does not guarantee receipt of back‐to‐back
packets.
Purpose
To display RMON capture entries, configure, enable, or disable capture entries, and clear capture
entries.
Commands
For information about...
show rmon capture
set rmon capture
clear rmon capture
show rmon capture
Use this command to display RMON capture entries and associated buffer control entries.
Syntax
show rmon capture [index [nodata]]
Parameters
index
nodata
Defaults
If no options are specified, all buffer control entries and associated captured packets will be
displayed.
Mode
Switch command, read‐only.
13-20 RMON Configuration
(Optional) Displays the specified buffer control entry and all captured
packets associated with that entry.
(Optional) Displays only the buffer control entry specified by index.
Refer to page...
13-20
13-21
13-22