Show Logging Local; Set Logging Local - Enterasys D2 D2G124-12P Cli Reference Manual

D-series ethernet switches
Table of Contents

Advertisement

Parameters
mnemonic 
all
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to reset the logging severity level to 6 for SNMP.
D2(rw)->clear logging application SNMP

show logging local

Use this command to display the state of message logging to the console and a persistent file.
Syntax
show logging local
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display the state of message logging. In this case, logging to the 
console is enabled and logging to a persistent file is disabled.
D2(su)->show logging local
Syslog Console Logging enabled
Syslog File Logging disabled

set logging local

Use this command to configure log messages to the console and a persistent file.
Syntax
set logging local console {enable | disable} file {enable | disable}
Resets the severity level for a specific application to 6. Valid mnemonic 
values and their corresponding applications are listed in Table
page 12‐8.
Resets the severity level for all applications to 6.
show logging local
12‐38 on 
D-Series CLI Reference 12-9

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Enterasys d2 d2g124-12D2g124-12D2g124-12p

Table of Contents