Table of Contents
Advertisement
Configuring Priority to Transmit Queue Mapping
Parameters
port‐string
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to reset
D2(rw)->clear port priority ge.1.11
Configuring Priority to Transmit Queue Mapping
Purpose
To perform the following:
•
View the current priority to transmit queue mapping of each physical port.
•
Configure each port to either transmit frames according to the port priority, set using the set
port priority command described in "set port priority" on page 10‐3, or according to a priority
based on a percentage of port transmission capacity, assigned to transmit queues using the set
port txq command described in "set port txq" on page 10‐7.
•
Clear current port priority queue settings for one or more ports.
Commands
For information about...
show port priority-queue
set port priority-queue
clear port priority-queue
show port priority-queue
Use this command to display the port priority levels (0 through 7, with 0 as the lowest level)
associated with the current transmit queues (0 being the lowest priority) for each selected port. A
frame with a certain port priority is transmitted according to the settings entered using the set
port priority‐queue command described in "set port priority‐queue" on page 10‐5.
Syntax
show port priority-queue [port-string]
10-4 Port Priority and Rate Limiting Configuration
Specifies the port for which to clear priority. For a detailed description of
possible port‐string values, refer to "Port String Syntax Used in the CLI" on
page 4‐1.
ge
.1.11 to the default priority:
Refer to page...
10-4
10-5
10-6
Hide quick links:
Advertisement
Table of Contents
