Clear Policy Port; Configuring Policy Class Of Service (Cos) - Enterasys D2 D2G124-12P Cli Reference Manual

D-series ethernet switches
Table of Contents

Advertisement

Example
This example shows how to allow Gigabit Ethernet ports 5 through 15 in slot 1 to transmit frames 
according to policy profile 1:
D2(su)->set policy port ge.1.5-15 1

clear policy port

Use this command to remove a policy profile from one or more ports.
Syntax
clear policy port port-string profile-index
Parameters
port‐string
profile‐index
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to remove policy profile 10 from port 21 in slot 1:
D2(rw)->clear policy port ge.1.21 10

Configuring Policy Class of Service (CoS)

The D‐Series supports Class of Service (CoS), which allows you to assign mission‐critical data to a 
higher priority through the device by delaying less critical traffic during periods of congestion. 
The higher priority traffic going through the device is serviced first (before lower priority traffic). 
The Class of Service capability of the device is implemented by a priority queueing mechanism. 
Class of Service is based on the IEEE 802.1D (802.1p) standard specification, and allows you to 
define eight priorities (0‐7, with 7 granted highest priority) and up to 8 transmit queues (0‐7) for 
each port.
By default, policy‐based CoS is disabled on the device, and default or user‐assigned port‐based 
802.1D (802.1p) settings are used to determine traffic rate limiting. When policy‐based CoS is 
Specifies the port(s) from which to remove the policy profile. For a 
detailed description of possible port‐string values, refer to "Port String 
Syntax Used in the CLI" on page 4‐1.
Specifies the ID of the policy profile (role) to which the port(s) will be 
added. This value must match the profile‐index value assigned using the 
set policy profile command ("set policy profile" on page 9‐4) in order for 
a policy profile to be active on the specified port.
Note: It is recommended that you use Enterasys Networks NetSight Policy Manager as an
alternative to CLI for configuring policy-based CoS on the switches.
clear policy port
D-Series CLI Reference 9-15

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Enterasys d2 d2g124-12D2g124-12D2g124-12p

Table of Contents