Factory Default Settings; Default Settings For Basic Switch Operation - Enterasys D2 D2G124-12P Cli Reference Manual

D-series ethernet switches
Table of Contents

Advertisement

Factory Default Settings

Remotely using WebView™, Enterasys Networks' embedded web server application.
The Installation Guide for your D‐Series device provides setup instructions for connecting a 
terminal or modem to the switch.
Factory Default Settings
The following tables list factory default settings available on the D‐Series switch. 
Table 1-1 Default Settings for Basic Switch Operation
Feature
Switch Mode Defaults
CDP discovery protocol
CDP authentication code
CDP hold time
CDP interval
Cisco discovery protocol
Cisco DP hold time
Cisco DP interval timer
Community name
Console (serial) port
required settings
DHCP server
EAPOL
EAPOL authentication
mode
GARP timer
GVRP
History buffer size
IEEE 802.1 authentication
IGMP snooping
IP mask and gateway
IP routes
Jumbo frame support
Link aggregation control
protocol (LACP)
Link aggregation admin
key
1-2 Introduction
Default Setting
Auto enabled on all ports.
Set to 00-00-00-00-00-00-00-00
Set to 180 seconds.
Transmit frequency of CDP messages set to 60 seconds.
Auto enabled on all ports.
Set to 180 seconds.
Set to 60 seconds.
Public.
Baud rate: 9600
Data bits: 8
Flow control: disabled
Stop bits: 1
Parity: none
Disabled.
Disabled.
When enabled, set to auto for all ports.
Join timer set to 20 centiseconds; leave timer set to 60 centiseconds; leaveall
timer set to 1000 centiseconds.
Globally enabled.
20 lines.
Disabled.
Disabled. When enabled, query interval is set to 260 seconds and response
time is set to 10 seconds.
Subnet mask set to 0.0.0.0; default gateway set to 0.0.0.0.
No static routes configured.
Enabled on all ports.
Enabled.
Set to 32768 for all ports.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Enterasys d2 d2g124-12D2g124-12D2g124-12p

Table of Contents