Set Spantree; Show Spantree Version - Enterasys D2 D2G124-12P Cli Reference Manual

Table 6-28 show spantree Output Details (Continued)
Output
Bridge Forward Delay
Topology Change Count
Time Since Top Change
Max Hops

set spantree

Use this command to globally enable or disable the Spanning Tree protocol on the switch.
Syntax
set spantree {disable | enable}
Parameters
disable | enable
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to disable Spanning Tree on the device:
D2(su)->set spantree disable

show spantree version

Use this command to display the current version of the Spanning Tree protocol running on the
device.
Syntax
show spantree version
Parameters
None.
Defaults
None.
What It Displays...
Amount of time (in seconds) the bridge spends in listening or learning
mode. This is a default value, or is assigned using the set spantree
fwddelay command. For details, refer to
page 6-20.
Number of times topology has changed on the bridge.
Amount of time (in days, hours, minutes and seconds) since the last
topology change.
Maximum number of hops information for a particular Spanning Tree
instance may traverse (via relay of BPDUs within the applicable MST
region) before being discarded.
Globally disables or enables Spanning Tree.
set spantree
"set spantree fwddelay" on
D-Series CLI Reference 6-7