Show Spantree Output Details - Enterasys D2 D2G124-12P Cli Reference Manual

show spantree stats
Example
This example shows how to display the device's Spanning Tree configuration:
D2(su)->show spantree stats
Spanning tree status
Spanning tree instance
Designated Root MacAddr
Designated Root Priority
Designated Root Cost
Designated Root Port
Root Max Age
Root Hello Time
Root Forward Delay
Bridge ID MAC Address
Bridge ID Priority
Bridge Max Age
Bridge Hello Time
Bridge Forward Delay
Topology Change Count
Time Since Top Change
Max Hops
Table 6‐28 shows a detailed explanation of command output.
Table 6-28 show spantree Output Details
Output
Spanning tree instance
Spanning tree status
Designated Root MacAddr
Designated Root Port
Designated Root Priority
Designated Root Cost
Root Max Age
Root Hello Time
Root Forward Delay
Bridge ID MAC Address
Bridge ID Priority
Bridge Max Age
Bridge Hello Time
6-6 Spanning Tree Configuration
- enabled
- 0
- 00-e0-63-9d-c1-c8
- 0
- 10000
- lag.0.1
- 20 sec
- 2 sec
- 15 sec
- 00-01-f4-da-5e-3d
- 32768
- 20 sec
- 2 sec
- 15 sec
- 7
- 00 days 03:19:15
- 20
What It Displays...
Spanning Tree ID.
Whether Spanning Tree is enabled or disabled.
MAC address of the designated Spanning Tree root bridge.
Port through which the root bridge can be reached.
Priority of the designated root bridge.
Total path cost to reach the root.
Amount of time (in seconds) a BPDU packet should be considered valid.
Interval (in seconds) at which the root device sends BPDU (Bridge Protocol
Data Unit) packets.
Amount of time (in seconds) the root device spends in listening or learning
mode.
Unique bridge MAC address, recognized by all bridges in the network.
Bridge priority, which is a default value, or is assigned using the set
spantree priority command. For details, refer to
page 6-17.
Maximum time (in seconds) the bridge can wait without receiving a
configuration message (bridge "hello") before attempting to reconfigure.
This is a default value, or is assigned using the set spantree maxage
command. For details, refer to
Amount of time (in seconds) the bridge sends BPDUs. This is a default
value, or is assigned using the set spantree hello command. For details,
refer to "set spantree hello" on page 6-18.
"set spantree
"set spantree maxage" on page 6-19.
priority" on