Clear Port Broadcast - Enterasys D2 D2G124-12P Cli Reference Manual

clear port broadcast

Defaults
None.
Mode
Switch command, read‐write.
Usage
Per port broadcast suppression is hardset to be globally enabled on the D2. If you would like to
disable broadcast suppression, you can get the same result by setting the threshold limit for each
port to the maximum number of packets which can be received per second as listed in the
parameters section, above. The default broadcast suppression threshold for all ports is set to
14881.
Example
This example configures ports 1 through 5 with a broadcast limit of 50 pps:
D2(su)->set port broadcast ge.1.1-5 50
clear port broadcast
Use this command to clear the broadcast threshold limit to the default value of 14881 for the
selected port.
Syntax
clear port broadcast port-string threshold
Parameters
port‐string
Defaults
None.
Mode
Switch command, read‐write.
Example
This example clears the broadcast threshold limit to 14881 pps for ports 1 through 5:
D2(su)->clear port broadcast ge.1.1-5 threshold
4-30 Port Configuration
Select the ports for which to clear broadcast suppression thresholds. For a
detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 4‐1.