Warm Start - Craftsman 536.885213 Operator's Manual

electric s tarter overheates, itwill a u-
tomatically stop and canonly bere-
started w hen ithascooled t oa safe
temperature. Await o fabout 5to10
minutes isrequired toallow the
electric s tarter tocool.
9.
(Recoil Start) Rapidly pull the re-
coil starter handle. Do not allow
the recoil starter handle to snap
back. Slowly return the recoil start-
er handle,
10. If the engine does not start in 5 or 6
tries, See the "Trouble Shooting
Chart" Instructions.
11. (Electric Start) When the engine
starts, release the electric start
button,
12. (Electric Start) First disconnect the
power cord from the receptacle.
Then, disconnect the power cord
from the switch box.
13. As the engine warms up, move the
choke control to 1/2 choke posi-
tion. When the engine runs smooth-
ly, move the choke control to the
off position.
NOTE: Allow the engine to warm up for
several minutes before blowing snow in
temperatures below 0°E
WARM START
If restarting a warm engine after a short
shutdown, leave choke at "OFF" and do
not push the primer button. If the en-
gine fails to start, follow the Cold Start
instructions.
_lb WARNING: Never run en-
gine indoors or in enclosed,
poorly ventilated areas. En-
gine exhaust contains CARBON
MONOXIDE, AN ODORLESS AND
DEADLY GAS. Keep hands, feet,
hair and loose clothing away from
any moving parts on engine and
snow thrower.
The temperature of muffler and
nearby areas may exceed 150°1=.
Avoid these areas.
DO NOT allow children or young
teenagers to operate or be near
snow thrower while it is operating.
_hb ARNING: Do not attempt
to remove any item that may
become lodged in auger
without taking the following precau-
tions:
• Release auger drive lever.
• Move the ignition lever to the
stop position to stop the engine.
• Disconnect spark plug wire.
Do not place your hands in the
auger or discharge chute. Use a
pry bar.
F-011005M 12