Assembly; To Remove Cultivator From Carton; Checklist - Craftsman 536.292510 Owner's Manual

In the state of California the spark arrester is on federal lands. A spark arrester/muffler is
required by law (Section 4442 of the Califor- available through your nearest Craftsman
nia Public Resources Code). Other states Authorized Service Center (See REPAIR
may have similar laws. Federal laws apply PARTS section in this manual).
Parts packed separately in carton (not shown full size)
1 - 5.3 Ounce 2-cycle Oil
1 - Owner's Manual (not shown)
A
CAUTION: Always wear safety
glasses or eye shields while assembling
the Craftsman cultivator.
The figure to the right shows the cultivator
completely assembled.
References to the right or left hand side
of the cultivator are from the viewpoint of
the operator's position behind the unit.
TO REMOVE CULTIVATOR FROM
CARTON
• Remove packing insert from carton.
• Lift the cultivator out of the carton and
place on a hard level surface.
• Loosen tee knobs. Tilt the cultivator
forward and rotate upper handle to the
upright position, making sure the throttle
is not caught between the handles. Then
tighten the tee knobs. See figure below.
• Tighten the handle hardware by holding
the curved head carriage bolt against the
outside of the lower handle while
tightening the tee knobs securely.
ht Left
Handle
Control
Depth
Stake
Tine
,/ CHECKLIST
Before you operate and enjoy your new
CRAFTSMAN CULTIVATOR, to ensure
that you receive the best performance and
satisfaction from this quality product, please
review the following checklist:
J All assembly instructions have been
completed.
,I No loose parts in carton.
,/ All fasteners have been properly
tightened.
While learning how to use your CRAFTS-
MAN CULTIVATOR, pay extra attention to
the following important items:
,/,/ Fuel tank is filled with correct gasoline
and oil mixture.
,/,/ Become familiar with the location and
function of all controls. Operate
controls before starting engine.