England's Stove Works 55SHP22 Installation Manual
Englander stoves pellet stoves, wood stoves, gas stoves, multi-fuel stoves installation guide
Hide thumbs
Also See for 55SHP22:
- Installation and operation manual (26 pages) ,
- Installation & operation manual (61 pages)
Advertisement
Quick Links
Pellet Stoves
P.O. Box 206
Monroe, VA 24574
BEFORE BEGINNING THERMOSTAT INSTALLATION BE CERTAIN
THE STOVE IS UNPLUGGED AND COMPLETELY COOL. DEPENDING
ON WHICH STOVE THE THERMOSTAT IS BEING INSTALLED ON,
THE CONTROL BOARD MAY NEED TO BE REMOVED FOR
1. Using a small, slotted screwdriver (often referred to as a jeweler's screwdriver),
loosen the two screws on the front of the J18 thermostat terminal, shown below
and remove the jumper which is installed in the terminal from the factory. This
jumper should be set aside and saved.
Connect
thermostat
wires here
(J18)
2. Insert one of the thermostat wires into each of the terminals on the bottom of the
J18 thermostat connection block and tighten the screws on the front of the
thermostat terminal. The thermostat wires should be securely held in place by
these screws (remember that the thermostat is not polarity specific, so it will not
matter which wire goes into either terminal).
Wood Stoves
Gas Stoves
Multi-Fuel Stoves
www.englanderstoves.com
Installing the PU-DTSTAT
INSTALLATION.
Phone: (800) 516-3636
Fax: (434) 929-4810
Advertisement
Related Manuals for England's Stove Works 55SHP22
Summary of Contents for England's Stove Works 55SHP22
- Page 1 BEFORE BEGINNING THERMOSTAT INSTALLATION BE CERTAIN THE STOVE IS UNPLUGGED AND COMPLETELY COOL. DEPENDING ON WHICH STOVE THE THERMOSTAT IS BEING INSTALLED ON, THE CONTROL BOARD MAY NEED TO BE REMOVED FOR 1. Using a small, slotted screwdriver (often referred to as a jeweler’s screwdriver), loosen the two screws on the front of the J18 thermostat terminal, shown below and remove the jumper which is installed in the terminal from the factory.
- Page 2 5. After mounting the thermostat on the wall and reinstalling all panels removed from the stove, the batteries can be inserted into the thermostat. Once powered on, the fan control switch (lower left switch) of the thermostat must be slid to the word “On”...
- Page 3 6. Consult the Owner’s Manual of your stove (and see the chart below) for more details on how the thermostat works with your control board to manage heat output and fuel usage. Stove Thermostat Function Thermostat puts stove into idle 25‐PDV mode when the call for heat is 55‐SHP22 gone (control board does not 55‐TRP22 ...