Bosch SHX98M09UC-53 Getting Started Manual

For Proper Drying Always use Rinse Agent even if your detergent containes Rinse Agent
o Add Rinse Agent when the
"Refill Rinse Aid" message
appears on the display
dispensed
,-b 3 4 ,_
Turn
Decrease Increase
for for
Streaks on Spots on
glasses glasses
= Use fresh powdered detergent
for best results
1 tablespoon will clean most loads
°Add * 3 tablespoons Max, do not overfill
Detergent * When using detergent tabs, Jay them
flat to avoid contact with the cover
Using too much detergent can
damage your dishware
oTo close
Slide cover fully left
_ ush rear of cover down
firmly until you hear the
/
CLICK _-
® If you should o Push the blue button in
need to open (NOT DOWN)
the cover
In order to activate a touch control button, place the entire finqertip over
the button for three seconds
The first time you use your dishwasher you must select a language. These choices
will appear on the display screen:
• AE (American English) / CF (Canadian French) / MS (Mexican Spanish)
Touch the - or + button until the desired language flashes, then touch the
MENU/OK button to save the setting
Hidden Top Controls
_the aoor]
I
_ _
[5_ Close the J
t I to star_j
door
-3
I ) Y I [4_ Touch start j
*ALW
FREQUENTLY ASKED
QUESTIONS
Run Time
To save energy, this dishwasher has a "Smart Control" that
automatically adjusts the cycle 3ased on soil loads and incom-
ing water temperature. The "Smart Control" makes decisions
that can cause the cycle time and water usage to adjust at
discrete times, and suddenly change in midcycle. The cycle
times listed in the Use ant Care manual are based on normal soil
loads and 120°F incoming water and will vary based on your
actual conditions.
When is the Cycle Complete
Depending on model you can tell when your unit has completed
the cycle in one of the following ways. Please refer to your Use
and Care manual for complete details
= Countdown Display at "0'
- Clean Light illuminates
Cycle completion signal sounds (tone adjustable)
- Cycle indicator light that shines on floor goes out
Canceling a Cycle
Be careful of splash=out.
*To cancel a cycle already in process, open the door only far
enough to expose the control panel, the display will show:
* "Close the door"
Approximate remaining cycle time
* The current cycle
= The cycle phase
* "Cancel Program"
Press the - button. The display will show "To cancel, close the
door". The dishwasher will then drain the remaining water and
shut off.
To Contact Customer Service
With the dishwasher door open, locate the label on the right side
of the door There you will find the:
= Model Number
Serial Number (FD#########)
- Toll Free Customer Service Phone Number