Specifications; Power Requirements; Dimensions - Altec Lansing ADA880 User Manual

Introduction
The ADA880 is a technologically advanced multimedia amplified speaker system featuring Dolby Digital AC3 and Dolby Pro-Logic surround
sound and stereo reproduction. The amplifier inputs can simultaneously operate on analog and digital (S/PDIF)* audio signals.
The unit is comprised of a subwoofer and two satellite speakers. This combination provides surround sound on a desktop by
utilizing side firing speakers. For enhanced surround sound the top speaker portion of each satellite can be separated and placed on
a provided stand with long speaker wires. This enables the separated speakers to be placed for best surround sound performance.
Equalizer circuitry automatically resets to conform to the changes that take place when the speakers are separated.
The satellite speakers are magnetically shielded and can be placed close to a monitor without disturbing images. The speaker in the
subwoofer is not magnetically shielded and should not be placed close to a monitor.
Subwoofer frequencies are non directional, therefore, the subwoofer does not have to be located in any particular relationship to the
satellite speakers. Placing it on the floor close to a wall, corner of a room or under a desk gives excellent results.
The main satellite speaker has status indicators to show the various conditions of operation. A master volume control is used to
separately adjust bass, center, surround and treble settings. Once the individual functions are set, the control reverts back to
becoming a master volume control. A remote control unit is supplied that can access all the manual functions. The remote control
has a mute function that is not available when using the controls manually.
The AC3/PRO-LOGIC/STEREO decode circuits operate automatically. If the unit is in the STEREO or PRO-LOGIC mode and an
AC3 signal appears at the input of the amplifier, the circuitry automatically switches over to AC3. This and other automatic features
are explained under "Using the Speaker System."
If analog and digital signals appear at the input of the amplifier, the analog signal is automatically reduced in volume level.
*Sony/Philips Digital Interconnect Format.

SPECIFICATIONS

System Response
Total Audio Output
Input Impedance
Analog Input Sensitivity
Digital Input
SATELLITE AMPLIFIED
SPEAKERS
Drivers
Power
Signal-to-Noise Ratio
SUBWOOFER
Driver
Power
Crossover Frequency
Signal-to-Noise Ratio
20Hz – 20kHz
80 Watts
>10k Ohms
300mV for full output
S/PDIF*
Four 3" full range
Two 1" Tweeters
40 Watts (10 watts per
driver) at .10% THD
>70dB
One 8" dual voice coil
40 watts at 1% THD
150Hz
>70dB

POWER REQUIREMENTS

USA/Canada
Europe/United
Kingdom and various
Asian countries
UL/CU/CE Approved

DIMENSIONS

Subwoofer
Main Speakers
Surrounds
*Sony Philips Digital Interconnect Format
120V/240W/60Hz
230V/240W/50Hz
345mm Wide X
290mm Deep X
235mm High
102mm Wide X
130mm Deep X
155mm High
120mm Wide X
105mm Deep X
108mm High
3