Wall Mount Installation - Empire Heating Systems SR-10T-3 Installation Instructions And Owner's Manual

Refer to Figures 7, 8 and 9 for measurements in order to locate
(4) mounting holes on wall. Figures 7, 8 and 9 are the front views
of the heaters.
1. Remove lower louver from casing assembly (2 screws).
2. Remove reflector from casing assembly (2 screws).
3. Remove upper louver from casing assembly (2 screws).
(28 mm)
(51)
(479 mm)
(102 mm)
Figure 7 (SR-10T)
(457mm)
(356mm)
(28mm)
(479mm)
(102mm)
Figure 8 (SR-18T)
Page 10

WALL MOUNT INSTALLATION

(300 mm)
(198 mm)
(51)
(559 mm)
(559mm)
(52mm)
(51mm)
(51)
(28mm)
(479 mm)
(102 mm)
MIN
(51 mm)
On Solid Wall
1. After locating mounting holes, attach (4) #10 x 1" (25mm)
screws provided into the wall. Do not completely tighten
screwheads to the wall, leave a 1/8" (3mm) gap between
screwheads and wall.
2. Mount heater onto the (4) screwheads and complete tightening
screwheads into the wall.
Attention! Use the following steps to properly align the upper
louver and the reflector with the heat shield.
a. When replacing upper louver, be sure the bottom lip of
upper louver goes behind the heat shield.
b. When replacing reflector, be sure the top lip of reflector
goes in front of the heat shield.
3. Connect the gas line.
On Sheet Rock Wall
1. After locating mounting holes, drill (4) 5/16" (8mm) diameter
holes into the wall.
2. Insert (4) plastic expansion anchors provided into the holes.
3. Tighten (4) #10 x 1" (25mm) screws provided into the plastic
expansion anchors. Do not completely tighten screwheads to
the plastic expansion anchors, leave a 1/8" (3mm) gap between
screwheads and plastic expansion anchors.
(613mm)
(511mm)
(51)
2" (51 mm)
Figure 9 (SR-30T)
(559 mm)
16941-5-0907