Wxr100 Leds - 3Com WX2200 - Wireless LAN Controller Hardware Installation Manual

Table 4 WX1200, WX4400, and WX2200 Status LEDs (continued)
LED
MAP
(WX1200 only)

WXR100 LEDs

Figure 5 shows the locations of the WXR100 LEDs. Table 5 describes the
LEDs.
Figure 5 WXR100 LEDs
Appearance Meaning
Solid green For a MAP access point's active link, with
PoE enabled, all the following are true:
Alternating green MAP access point is booting with an image
and amber received from the WX switch.
If the LED remains in this state indefinitely,
the boot or configuration attempt has
failed.
Solid amber PoE is on but no MAP access point is
connected to the link.
Blinking amber MAP is not connected or is unresponsive,
or there is a PoE problem.
Unlit Port is not configured as a MAP access
port, or PoE is off.
FN LED
1
Link LED
Hardware Features
MAP access point has booted.
MAP access point has received a valid
configuration from the WX switch.
Management link with a MAP access
point is operational.
MAP LED
2
Power
supply LED
17