Emerson EWC19T3, EWC27T3 Owner's Manual page 18

AUTOMATIC CLOCK SETTING
Make sure ...
•
The TV/DVD/VCR is turned on.
•
Confirm the TV/DVD/VCR is receiving a RF
(Radio Frequency) signal from either an antenna or
cable system connection using the ANT IN jack on
the rear of the TV/DVD/VCR.
NOTE:
•
If a cable converter box is being used, make sure it
is powered on.
•
You must use the TV/DVD/VCR remote control to
perform the clock setting procedure.
1
Select "SETTING CLOCK"
Press the SETUP button on the
remote control.
Press the Arrow button K or L to
select "SETTING CLOCK".
Press the ENTER button to enter
"SETTING CLOCK" menu.
2
Set "AUTO CLOCK" to [ON]
Press the ENTER button until
AUTO CLOCK [ON] appears.
3
Begin "AUTO CLOCK CH SEARCH"
Press the Arrow button L to select "AUTO CLOCK
CH SEARCH".
Press the ENTER button.
•
The TV/DVD/VCR is now
searching for the station which
contain the auto clock set signal.
The search for a signal may take
up to 20 seconds per channel.
•
"_ _" appears at the lower left of
the screen when the search has
ended.
•
Auto Clock station- write down
the number(s) that appear on the
screen. These are the auto clock
station(s) in your area. See item
4 below.
•
If no number(s) appear on the TV screen, there are
no stations in your area which contain the Auto
Clock signal. Auto Clock Setting is not possible.
Please use Manual Clock Setting on page 17.
Press the SETUP button to exit the screen.
NOTE: During Auto Clock CH Search, the picture
may be distorted. This is normal.
4
Enter the channel number that contains the
Automatic Clock Setting Signal
Press the SETUP button on the remote control.
Press the Arrow button K or L to
select "SETTING CLOCK".
Press the ENTER button to enter
"SETTING CLOCK" menu.
Press the Arrow button L to select
"AUTO CLOCK CH".
Press the ENTER button, then
press the Arrow button B or s
until you locate Auto Clock Set
station number. See item 3 above.
Press the SETUP button to exit the
screen.
5
Once the TV/DVD/VCR is turned off , it will period-
- TV/VCR SETUP -
ically check and set the correct date and time.
TIMER PROGRAMMING
B SETTING CLOCK
CHANNEL SET UP
USER'S SET UP
V-CHIP SET UP
LANGUAGE [ENGLISH]
CAPTION [OFF]
ZERO RETURN
TIME SEARCH
INDEX SEARCH
– SETTING CLOCK –
B AUTO CLOCK [ON]
AUTO CLOCK CH SEARCH
AUTO CLOCK CH [02]
MANUAL CLOCK SET
D.S.T. [OFF]
– SETTING CLOCK –
AUTO CLOCK [ON]
B AUTO CLOCK CH SEARCH
AUTO CLOCK CH [02]
MANUAL CLOCK SET
D.S.T. [OFF]
– AUTO CLOCK CH SEARCH –
08 10 13
_ _
- 18 -
Turn off the TV/DVD/VCR
- TV/VCR SETUP -
TIMER PROGRAMMING
B SETTING CLOCK
CHANNEL SET UP
USER'S SET UP
V-CHIP SET UP
LANGUAGE [ENGLISH]
CAPTION [OFF]
ZERO RETURN
TIME SEARCH
INDEX SEARCH
– SETTING CLOCK –
AUTO CLOCK [ON]
AUTO CLOCK CH SEARCH
B AUTO CLOCK CH [ 45]
MANUAL CLOCK SET
D.S.T. [OFF]
EN
1C29