Advertisement
Quick Links
MODELS 4934 & 8983
TWO-HANDLE WIDESPREAD
SPOUT
HANDLE
KNOB
VALVE
BODY
SPOUT
MOUNTING
NUT
1/2" NPT
THREADED
CONNECTIONS
HOT
Complies with ASME A112.18.1M and CSA B125
CAUTION:
Before turning water on during either rough-in or trim-out, make sure that the cartridge retainer nuts are in place. The cartridges
and retainer nuts were properly installed and tested before leaving the factory. Although it is unlikely, it is nevertheless possible
that through the handling of the valve by any number of persons the cartridge retainer nuts may not be properly installed. This
should be carefully checked at time of rough-in and trim-out. If the retainer nuts are not properly installed, water pressure could
force the cartridge out of the casting. Personal injury or water damage to the premises could result.
®
LAVATORY FAUCET
FLOW RATOR
AERATOR
SPOUT
MOUNTING
WASHER
TAILPIECE
NUT
COLD
SPOUT
UNION TEE
4" - 16" CENTERS
Always turn water off before disassembling the valve. Open valve handle to releive water pres-
sure and to insure that complete water shut-off has been accomplished.
INSTALLATION INSTRUCTIONS
DECK
4-5/16"
MOUNTING
WASHER
MOUNTING
NUT
WATER
SUPPLY LINES
(NOT FURNISHED)
THESE INSTRUCTIONS MUST BE
LEFT WITH HOMEOWNER
1-1/4" MAX.
DECK
THICKNESS
WASHER
MOUNTING
NUT
5-1/8"
SPOUT INSTALLS THROUGH 1" MINIMUM DIAMETER HOLE.
VALVE INSTALLS THROUGH 1-1/8" MINIMUM DIAMETER HOLE.
MT143B
* SPOUT TUBE
(See note 5, Waste
Assembly Installation)
Advertisement
Related Manuals for Moen 4934
Summary of Contents for Moen 4934
-
Page 1: Installation Instructions
MT143B MODELS 4934 & 8983 ® INSTALLATION INSTRUCTIONS THESE INSTRUCTIONS MUST BE LEFT WITH HOMEOWNER TWO-HANDLE WIDESPREAD LAVATORY FAUCET FLOW RATOR AERATOR SPOUT HANDLE KNOB DECK 4-5/16" 1-1/4" MAX. MOUNTING SPOUT VALVE DECK WASHER MOUNTING BODY THICKNESS WASHER SPOUT MOUNTING MOUNTING TAILPIECE WASHER... - Page 2 Installation Instructions Fill the recess under the valve and spout escutcheons with plumber's putty (not included). Place spout with es- cutcheon and adapter in place down through the center hole. Put washer over spout shank. Screw on mounting nut and make hand-tight. Turn mounting nuts on valve bodies all the way down, for basin clearance, and drop on mounting washers.
- Page 3 Lavatory Lift Rod and Waste Assembly 1. Thoroughly clean around drain opening in lavatory sink. Apply CAUTION: To avoid the lift rod 1/4 inch bead of plumber's putty (not furnished) around the bot- knob rubbing against spout, do tom side of seat. not install rod any lower than 2.
-
Page 4: Consumer Information
In Canada call: Toronto, 905-829-3400 Rest of Canada, 1-800-465-6130 ® © Copyright 1995 Moen Incorporated 25300 Al Moen Drive, North Olmsted, OH 44070-8022, U.S.A. Moen Incorporated In Canada: Printed in U.S.A. MT143B SEP 95 Moen Inc. 2816 Bristol Circle, Oakville, Ontario L6H5S7...