Replacing Batteries; Remote Controls; Door/Window Sensor - X-10 POWERHOUSE PS561 Owner's Manual

REPLACING BATTERIES

REMOTE CONTROL
For HT544 use 9V alkaline battery.
For KF574 use 6V Eveready A544,
Radio Shack 23-469, or equivalent.
For SH624 use four AAA alkaline bat-
teries.
After replacing batteries, the following
steps are necessary to determine that
the Console still recognizes the Re-
mote Control.
1. Place the INSTALL/RUN switch
on the Console to RUN 2.
2. Press [ARM] on the Remote Con-
trol. If the system arms, the Con-
sole recognized the Remote Control
and no further action is necessary.
If the system did not arm:
1, Place the INSTALL/RUN switch
on the Console to INSTALL.
Press [ARM] on the Remote Con-
2.
trol. The Remote Control transmits
a random code to the Console. The
Console acknowledges this with a
beep and logs in the Remote Con-
trol. If you do not hear a beep,
press [CODE] with a pencil and
then press [ARM].
RTS04
The RT504 uses four AAA alkaline
batteries but it does not require any in-
stallation. Just set its Housecode dial
to match the Console and it's ready to
use.
DOOR/WINDOW SENSORS
If any of the Console's zone indicators
flash slowly, the Door/Window Sensor
for that zone has not reported in dur-
ing the last 4 hours. This is most likely
caused by a dead battery in the Door/
Window Sensor.
After replacing the battery in the
Door/Window Sensor, the following
steps are necessary to determine that
the Console still recognizes the sensor.
1. Place the INSTALL/RUN switch
on the Console to RUN 2.
2. Press [TEST] on the sensor. If the
Console chimes, it recognized the
sensor and no further action is nec-
essary.
If you did not hear a chime when
you pressed [TEST]:
1. Place the INSTALL/RUN switch
on the Console to INSTALL.
2. Press [TEST]. The Door/Window
Sensor transmits a code to the Con-
sole. The Console acknowledges
this with a beep and logs in the
code.
The Door/Window Sensor will nor-
mally be logged into the SAME zone
number as it was before you replaced
the battery. However, if you replace
the battery in the Door/Window Sen-
sor when its zone light was NOT
flashing, the Door/Window Sensor is
logged into the next sequential zone
(instead of the same zone as it was).
To avoid this, remove the old battery
and wait at least 4 hours before install-
27