Setting Up Remote Modules; Lamp Modules; Wall Switch Modules - X-10 POWERHOUSE PS561 Owner's Manual

SETTING UP REMOTE MODULES

SETTING UP

LAMP MODULES

When the alarm trips, lamps connect-
ed to Lamp Modules (set to the same
Housecode as the Console) flash on
and off for the duration of the alarm.
After 4 minutes (or when you disarm
the alarm) the lamps stop flashing and
remain on.
If you arm the system to give an exit
delay, Lamp Modules set to the same
Housecode and Unit Code as the Con-
sole turn on during the exit countdown
time. You can also control Lamp Mod-
ules set to this code from the [LIGHT
ON] and [LIGHT OFF] buttons on the
HT544 and KF574 Remote Controls,
or from the [SECURITY LIGHT] but-
tons on the SH624 Remote Control.
Choose a lamp you wish to be part of
the security system. Make sure the
lamp's on/off switch is on and plug the
lamp into the Lamp Module, Model
No. LM465 (sold separately). Plug the
Lamp Module into any convenient
outlet. Set the Housecode and Unit
Code dials on the Lamp Module to the
same letter and number as you set on
the Console.
SETTING UP

WALL SWITCH MODULES

When the alarm trips, lights connected
to Wall Switch Modules (set to the
same Housecode as the Console) flash
on and off for the duration of the
alarm. After 4 minutes (or when you
disarm the alarm) the lights stop flash-
ing and remain on.
If you arm the system to give an exit
delay, Wall Switch Modules set to the
same Housecode and Unit Code as the
Console turn on during the exit count-
down time. You can also control Wall
Switch Modules set to this code from
the [LIGHT ON] and [LIGHT OFF]
buttons on the HT544 and KF574
Remote Controls or from the
[SECURITY LIGHT] buttons on the
SH624 Remote Control.
Choose a light which is presently con-
trolled by a wall switch.
breaker panel or fuse box. Replace the
wall switch with Wall Switch Module,
Model No. WS467 (sold separately).
Set the House and Unit Code on the
Wall Switch Module to the same letter
and number as the Console.
c
l
E
13