Sleep Timer - Emerson Research iC200 Owner's Manual

Sleep Timer

The Sleep Timer allows you to operate the radio or iPod
while you are falling asleep and then shuts the power off automatically.
1.) Turn the system ' On' and operate the radio or iPod
Adjust the Volume control to the desired level for falling asleep, but remember
that the level you set for falling asleep is that same level that you will hear in the
morning if you are waking to radio or iPod
2.) Press the Sleep button on the top panel.
The display will briefly show "L:30"
and the SLP (Sleep) indicator will
appear.
The radio or iPod
30 minutes and then shut off
automatically.
3.) To change the amount of Sleep time depress and hold the Sleep button and
press the Tuning/Skip
on the remote control to decrease or increase the amount of sleep time from
"01" minutes to "99" minutes.
NOTE: When you change the Sleep timer from the original 30-minute default
setting your new setting becomes the new default setting.
For example if you change the Sleep timer setting from 30 minutes to 45
minutes, 45 minutes becomes the new default Sleep timer setting until you
change it again.
4.) When the Sleep timer counts down to "00" the power shuts off automatically.
NOTE: If you set the Sleep timer for 60 minutes in the iPod mode, make
sure you have selected an Album or a Playlist that is at least 60 minutes
long. Otherwise the iPod
Playlist, but the system Power will remain ' On' until the Sleep timer counts
down to "00".
iC200_NCab050307.p65
®
will operate for
or buttons on the top panel or the
®
will stop at the end of your selected Album or
37
37
®
for up to 99 minutes
®
as usual.
®
.
3/5/2007, 11:29
/ buttons