Sony HVL-F10 Operating Instructions

3-862-667-11 (1)
5 To reduce the risk of electric shock,
do not disassemble this appliance,
but take it to a qualified serviceman
when service or repair work is
required. Incorrect reassembly can
Video Flash
cause electric shock when the
appliance is used subsequently.
6 The use of an accessory attachment
Operating Instructions
not recommended by the
Mode d'emploi
manufacturer may cause a risk of
fire, electric shock, or injury to
persons.
SAVE THESE
INSTRUCTIONS
HVL-F10
1998 by Sony Corporation Printed in Japan
IMPORTANT
A
SAFETY
1
INSTRUCTION
When using your electronic flash, basic
safety precautions should always be
followed, including the following:
2
1 Read and understand all instructions
before using.
2 Care must be taken as burns can
occur from touching hot parts.
3 Do not operate appliance if it has
been dropped or damaged, until it
has been examined by a qualified 3
serviceman.
4 To reduce the risk of electric shock,
do not immerse this appliance in
water or other liquids.
English
WARNING Troubleshooting
To prevent fire or shock hazard, do not
Symptom
expose the unit to rain or moisture.
The battery charge
To avoid electrical shock, do not open the
complete mark
cabinet. Refer servicing to qualified
appear in the viewfinder
personnel only.
(or display window).
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
The video flash does not
interference in a residential installation. This equipment
work even though the
generates, uses, and can radiate radio frequency energy
battery charge complete
and, if not installed and used in accordance with the
mark
viewfinder.
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
Specifications
or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
Dimensions
to try to correct the interference by one or more of the
following measures:
– Reorient or relocate the receiving antenna.
Mass
– Increase the separation between the equipment and
receiver.
Supplied accessory
– Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV
Design and specifications are subject to change without
technician for help.
notice.
You are cautioned that any changes or modifications not
expressly approved in this manual could void your
authority to operate this equipment.
Features
You can enjoy shooting subjects with the camcorder
Installing the battery
in photo mode under the following conditions:
• Insufficient light
(See Figure A)
• Too much brightness behind the subject (backlighting)
1 Remove the battery cover.
2 Install the two supplied batteries.
Cleaning
3 Reattach the battery cover.
Remove the video flash from the camcorder. Clean Notes
the video flash with a dry soft cloth. • When you replace the batteries, be sure to use one new
Sony CR123A lithium manganese battery. Use of
In case of stubborn stains, use a cloth lightly
another battery may present a risk of fire or explosion.
dampened with a mild detergent solution, then wipe
• Set the positive (+) and negative (–) terminals of the
the unit clean with a dry soft cloth.
batteries correctly as illustrated.
Never use strong solvents, such as thinner or benzine,
• To avoid damage from possible battery leakage,
as these damage the surface finish.
remove the batteries when you will not use the video
flash for a long time.
WARNING
The battery may explode if mistreated. Do not recharge,
disassemble, or dispose of in fire.
Français
AVERTISSEMENT
Afin d'éviter tout risque d'incendie ou
Remedy
d'électrocution, ne pas exposer l'appareil à la
Replace the batteries
pluie ou à l'humidité.
with one brand new
doesn't
Pour éviter tout risque de décharge
Sony lithium
électrique, n'ouvrez pas le boîtier. Ne confiez
manganese battery.
l'entretien qu'à un personnel qualifié.
Fresh batteries provide
power for about 400
flashes.
Caractéristiques
You need to go to a
Sony dealer (Sony
Votre caméscope autorise les prises de vue en mode
service facility) to
photo dans les cas suivants:
replace the bulb. Do not
appears in the
• Lumière insuffisante
replace the bulb
• Excès de luminosité derrière le sujet (contre-jour)
yourself.
Nettoyage
Retirez le flash vidéo du caméscope. Nettoyez le flash
About 1 9 / 2 1 / 2 3 / inches
16 4 16
vidéo à l'aide d'un chiffon sec et doux.
(About 40 57 55.5mm) (w/h/d)
Si les taches persistent, utilisez un chiffon légèrement
(Projections are not included in the
dimensions) humecté de savon liquide, puis essuyez à l'aide d'un
About 3 1 / oz. (90g)
5 chiffon doux et sec.
(including supplied battery)
N'utilisez jamais de solvants puissants tels que
One CR123A lithium manganese
diluant ou benzine, car ils peuvent endommager la
battery.
finition externe.
One pouch.
En cas de difficultés
This mark indicates that this product is
a genuine accessory for Sony video
products. When purchasing Sony video
Symptômes
products, Sony recommends that you
purchase accessories with this Le témoin d'état de charge
"GENUINE VIDEO ACCESSORIES"
des piles n'apparaît pas
mark.
dans le viseur (ou dans
l'afficheur).
Le flash vidéo ne
fonctionne pas alors que le
témoin de charge de la
batterie apparaît dans
le viseur.
Spécifications
Dimensions Environ 40 57 55,5 mm (1
2 1 / 2 3 / pouces) (l/h/p)
4 16
(Les saillies ne sont pas incluses
dans les dimensions)
Poids Environ 90 g (3 1 / on.)
5
(batterie fournie comprise)
Accessoires fournis Une batterie au lithium-manganèse
CR123A
Une housse
La conception et les spécifications sont modifiables sans
préavis.
Cette marque indique que ce
produit est un accessoire prévu pour
les produits vidéo Sony. Quand vous
achetez un produit vidéo Sony, nous
vous conseillons de vous procurer
des accessoires portant cette marque
"GENUINE VIDEO
ACCESSORIES".
Installation des piles
(Voir l'illustration A)
1 Retirez le couvercle des piles.
2 Installez les deux piles fournies.
3 Replacez le couvercle.
Remarques
• Lorsque vous remplacez les piles, veillez à utiliser une
batterie au lithium-manganèse CR123A Sony neuve.
• Placez les pôles positif (+) et négatif (–) des piles
Remèdes
correctement, comme indiqué sur l'illustration.
Remplacez les piles par
• Pour éviter tout dommage dû à une fuite d'électrolyte,
une batterie au lithium-
enlevez les piles quand vous ne comptez pas utiliser le
manganèse Sony neuve.
flash vidéo pendant un certain temps.
Des piles neuves
permettent d'effectuer
environ 400 flashs.
Consultez votre
distributeur Sony
(centre d'assistance
technique Sony) pour
remplacer l'ampoule.
Ne remplacez pas
l'ampoule vous-même.
9 /
16