Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Emerson CKD2328
Summary of Contents for Emerson CKD2328
- Page 1 AM/FM STEREO CLOCK RADIO with COMPACT DISC PLAYER POWER PANEL LOADING SYSTEM and REMOTE CONTROL (Model CKD2330 only) OWNER’ S MANUAL CKD2328 (Without Remote Control) CKD2330 (With Remote Control) Visit our web site at www.emersonradio.com CKD2328_2330_B0901103.p65 11/9/2003, 14:17...
-
Page 2: Important Safety Instructions
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE THIS PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. The lightning flash with arrow- WARNING: TO REDUCE THE head symbol, within an equi-... - Page 3 Thank you… … … … … … for purchasing this Emerson stereo clock radio with CD player and Power Panel CD loading system. The motorized front panel rotates 90 degrees at the touch of a button to make loading and unloading your CDs simple and easy. The Power Panel loading system also means that this radio takes up less space on the bedside table than other radios with drawer type CD loading systems.
-
Page 4: Important Notes
IMPORTANT NOTES • Avoid installing this unit in places exposed to direct sunlight or close to heat radiating appliances such as electric heaters, on top of other stereo equipment that radiates too much heat, places lacking ventilation or dusty areas, places subject to constant vibration and/ or humid or moist areas. -
Page 5: Preparation For Use
PREPARATION FOR USE UNPACKING AND SETUP • Carefully remove the main unit and the accessories from the display carton. Remove all the packing material from the unit and verify that you have the following items: Main unit, external AM antenna, and remote control (for model CKD2330 only). -
Page 6: External Am Antenna
External AM Antenna This unit utilizes an external AM loop antenna instead of a built in ferrite bar antenna. 1.) Insert the small white plug from the AM loop antenna into the AM antenna jack on the back of the radio. The plug can only be inserted one way. 2.) Attach the AM loop antenna to the antenna bracket on the back of the radio as shown. - Page 7 3.) Adjust the angle of the loop antenna until you find the position that provides the best AM reception. Note: If you find that AM reception is still unsatisfactory you can remove the loop antenna from the antenna mounting bracket and attach it to the wall with a thumbtack or small nail through the “keyhole”...
-
Page 8: Battery Back Up System
Battery Back Up System This model includes a battery back up circuit that will maintain the clock and alarm settings in the event of a temporary power interruption. The battery back up system requires two “AA” batteries, not included. The battery compartment is located on the bottom of the cabinet. - Page 9 Remote Control (Model CKD2330 Only) Model CKD2330 includes a credit card size 10-button remote control that allows you to operate the CD player, control the volume, and switch the system ‘ On’ and ‘ Off’ from across the room. The remote control operates on one, button-style lithium battery (Type CR2032 or equivalent), included.
-
Page 10: Protect Your Furniture
IMPORTANT BATTERY PRECAUTIONS: • Do not leave the exhausted battery lying around where a child or pet might play with or swallow it. • If the battery is swallowed contact a physician immediately. • Do not attempt to open the battery and do not dispose of the battery in a fire. -
Page 11: Power Source
POWER SOURCE This radio is designed to operate on 120V 60Hz AC only. Attempting to operate this radio on any other power source could cause damage to the unit and such damage is not covered by your warranty. Make sure the radio is connected to an AC outlet that is always “live”. Do not connect the radio to an outlet that is controlled by a wall switch. -
Page 12: Location Of Controls And Indicators
LOCATION OF CONTROLS AND INDICATORS FRONT PANEL BACK PANEL RIGHT SIDE PANEL CKD2328_2330_B091103.p65 28 29 30 11/9/2003, 14:51... - Page 13 1.) CD Power Panel (Flashing Blue Light When Opening). 2.) Mute Indicator (Red). 3.) ALARM SET Button. 4.) Snooze Sensor. 5.) CLOCK SET Button. 6.) Display AUTO DIMMER. 7.) PROGRAM Button. 8.) LCD Display. 9.) TUNING Control. 10.) Remote Sensor. 11.) Reverse SKIP/Search 12.) PLAY/PAUSE Button.
- Page 14 REMOTE CONTROL (Model CKD2330 Only) 1.) VOLUME – Button. 2.) MUTE Button. 3.) Reverse SKIP/SEARCH 4.) STOP Button. 5.) STANDBY/ON Button. 6.) PLAY/PAUSE Button. 7.) OPEN/CLOSE Button. 8.) RANDOM Button. 9.) Forward SKIP/SEARCH 10.) VOLUME + Button. 11.) Battery Compartment (Back Cabinet) CKD2328_2330_B091103.p65 Button.
-
Page 15: Setting The Clock
OPERATING INSTRUCTIONS • Make sure you have installed the back up batteries in the battery compartment. • Make sure you have installed the AM loop antenna and extended the FM lead wire antenna to its full length. • Make sure you have removed the remote control battery spacer from the remote handset (Model CKD2330 only). -
Page 16: Setting The Wake-Up Time
SETTING THE WAKE-UP TIME 1.) Depress and hold the ALARM SET button. The display will change from clock time to wake-up time and show “7:00 to adjust the display to the correct wake-up hour, AM or PM. 2.) Continue to depress the ALARM SET button and repeatedly press the MINUTE button to adjust the display to the correct wake-up minute. -
Page 17: Listening To The Radio
LISTENING TO THE RADIO 1.) Slide the CD/RADIO selector switch, located on the top cabinet, to the RADIO position. 2.) Press the STANDBY/ON (model CKD2330 only) to turn the system ‘ On’ . The Standby indicator goes off and an AM or FM radio frequency appears on the display. 3.) Select the desired band –... -
Page 18: Hints For Better Reception
Hints For Better Reception – Adjust the position and direction of the FM lead wire antenna until you find the position and direction that provides the best reception. AM Loop Antenna FM Wire Antenna – Adjust the direction of the AM loop antenna that you connected to the back of the radio. -
Page 19: Playing Compact Discs
PLAYING COMPACT DISCS NOTE: Although this CD player can read CD-R and CD-RW discs, in addition to normal CDs, the playability of CD-R and CD-RW discs may be effected by the type of software that was used to create the discs, as well as the quality and condition of the blank media you are using. - Page 20 4.) The Power Panel will rotate 90 degrees to allow you to load your disc in the CD player. Before loading your own disc be sure to remove the dummy CD transit card from the player and discard it. 5.) Place your disc on the center spindle with the printed label side facing you. Gently press on the disc near the center hole to insure that the disc is properly ‘...
- Page 21 7.) Press the PLAY/PAUSE (Model CKD2330 only). Playback begins on track 1 and the PLAY indicator appears in the display. Adjust the VOLUME controls to the desired level. 8.) Playback will continue until the last track has played then the disc stops, the PLAY indicator disappears, and the display again shows the total number of tracks on the disc.
- Page 22 PAUSE Control To pause momentarily during CD playback press the PLAY/PAUSE button on the front panel or on the remote control (Model CKD2330 only) again. The sound stops and the PLAY indicator flashes but the disc continues to spin. PLAY Press the PLAY/PAUSE button again to cancel the Pause mode and resume normal playback.
-
Page 23: Special Playback Modes
SPECIAL PLAYBACK MODES REPEAT Playback You can program the player to continuously repeat a single track or the entire disc. The Repeat mode can be selected while the disc is playing or while the disc is stopped. Single Track Repeat Select the track to be repeated and then press the REPEAT button on the front panel once. - Page 24 RANDOM Playback (Model CKD2330 Only) When the Random Playback mode is selected all the tracks on the disc will be played in random order. Random Playback mode can be selected while the disc is playing or while the disc is stopped. Press the RANDOM button on the remote control (Model CKD2330 Only).
-
Page 25: Programmed Playback
PROGRAMMED PLAYBACK Use the Programmed Playback feature to play up to 20 tracks on a disc in any desired order. You may also program a particular track to play several times within a programmed sequence if desired. NOTES: (A.) You cannot program a disc while it is playing. Press the STOP stop playback and then follow the programming steps below. - Page 26 3.) Press the SKIP Forward track number to be programmed. Example: Track number 7. When the desired track number appears in the display press the PROGRAM button again. Track 7 is now entered in Program Memory number “01”. The program memory number now advances to number “02” and continues flashing. 4.) Repeat step 3, selecting a different track number each time until you have entered up to 20 tracks in the program memory.
- Page 27 6.) When the program is completed the player stops and the display again shows the total tracks on the disc. However the PROGRAM indicator remains in the display and the player remains in the Programmed Playback mode. If you press the PLAY/PAUSE again.
-
Page 28: Alarm Function
ALARM Function You can use the alarm function to wake you to an electronic buzzer tone, the radio, or your favorite CD. First press the ALARM SET button on the front panel to check the Wake Up time setting. Adjust the Wake Up time if necessary. Then press the ALARM ON/OFF button on the top panel. - Page 29 Wake To CD Load the desired CD, begin playback and adjust the volume to the desired level. Press the STANDBY/ON button to put the system in the Standby (Power ‘ Off’ ) mode. Set the MUSIC /BUZZER switch on the top panel to the MUSIC position.
-
Page 30: Snooze Function
SNOOZE Function After the alarm turns on in the morning you can use the Snooze function to grab a few more minutes sleep before the alarm sounds again. To activate the Snooze function you can press the SNOOZE button on the top cabinet, or you can simply wave your hand in front of the Snooze Sensor on the front panel. - Page 31 SLEEP TIMER (Front Panel Only) This system includes a programmable Sleep Timer that allows you to fall asleep from 59 minutes of music and then shuts the power ‘ Off’ automatically. To Operate The Sleep Timer: 1.) Turn the system ‘ On’ and operate either the Radio or CD function as usual. 2.) Adjust the Volume level controls to the desired level.
- Page 32 NOTES: • You can shut the unit off manually before the Sleep Timer counts down to “00” by pressing the STANDBY/ON Timer by pressing the SNOOZE button. • Remember that if you are falling asleep to CD you will also wake to CD, and if you fall asleep to the radio you will also wake to the radio.
-
Page 33: Display Dimmer
MUTE Function (Model CKD2330 Only) To stop the sound from the speakers temporarily press the MUTE button on the remote control handset. The Mute indicator light (red) comes on. The sound stops but the unit remains ‘ On’ . Press the MUTE button again to cancel Mute function and restore the sound. -
Page 34: Care And Maintenance
CARE AND MAINTENANCE COMPACT DISC CARE • To remove a disc from its storage case, press down on the center of the case and lift the disc out, holding it carefully by the edges. • Fingerprints and dust should be carefully wiped off the disc’ s recorded surface with a soft cloth.Unlike conventional records, compact discs have no grooves to collect dust and microscopic debris, so gently wiping with a soft cloth should remove most particles. -
Page 35: Limited Warranty
Emerson Radio Corp. in the amount of $9.00 (not required by California residents) to cover shipping and handling costs, and enclose a copy of your proof of purchase. - Page 36 EMERSON Part No.: 16-2911B 309-01 Printed in China CKD2328_2330_B091103.p65 11/9/2003, 14:52...