Getting Started; Accessory List; Turning Power On And Off; Source Selection - Alpine CDE-143BT Manual

Getting Started

SOURCE/ 
Rotary encoder

/ENTER
e
AUDIO/SETUP
The illustration is for CDE-SXM145BT/CDE-143BT.

Accessory List

• Head Unit ..................................................................................1
• Power Cable ..............................................................................1
• Microphone ..............................................................................1
• Mounting Sleeve ......................................................................1
• Carrying Case*..........................................................................1
• Bracket Key ...............................................................................2
• Screw (M5 × 8) ..........................................................................4
• Owner's Manual..................................................................1 set
It is for CDE-SXM145BT/CDE-143BT.

Turning Power On and Off

Press SOURCE to turn on the unit.
Note
• The unit can be turned on by pressing any other button except  and
e (Release).
Press and hold SOURCE for at least 2 seconds to turn
off the unit.
Note
• The first time power is turned on, the volume will start from level 12.

Source Selection

Press SOURCE to change the source.
*1
TUNER  SIRIUSXM  DISC
*4 *5
 AUXILIARY
BT AUDIO
Displayed only when a siriusXM Tuner is
connected.(CDE-SXM145BT only).
Only for CDE-SXM145BT/CDE-143BT.
Only when the iPod/iPhone is connected.
Only when BT IN is set to ON. Refer to "Setting the
BLUETOOTH Connection (BT IN)" on page 23.
Only when AUX SETUP is set to ON. Refer to "Setting the AUX
SETUP mode" on page 21.
*2 *3
 USB AUDIO/iPod 
 TUNER

Detaching and Attaching the Front Panel

Detaching

1
Turn off the unit power.
2
Press e (Release) at the lower left side until the front
panel pops out.
3
Grasp the left side of the front panel and pull it out.
Notes
• The front panel may become hot in normal usage (especially the
connector terminals on the back of the front panel). This is not a
malfunction.
• To protect the front panel, place it in the supplied carrying case
(CDE-SXM145BT/CDE-143BT only).
• When detaching the front panel, do not apply excessive force as it may
result in malfunction.

Attaching

1
Insert the right side of the front panel into the main unit.
Align the groove on the front panel with the projections
on the main unit.
2
Push the left side of the front panel until it locks firmly into
the main unit.
Notes
• Before attaching the front panel, make sure that there is no dirt or dust
on the connector terminals and no foreign object between the front
panel and the main unit.
• Attach the front panel carefully, holding the sides of the front panel to
avoid pushing buttons by mistake.
9
-EN