Contents Safety Precautions .......... 3 Picture Zoom ......... 20 Features ............5 Reset ............ 20 Accessories ............. 5 Sound Menu ..........20 Rear View and Peripheral Connections ..6 Volume ..........20 Remote Control Buttons ........ 7 Equalizer ..........20 Preparation ............
Page 3
Appendix A: PC Input Typical Display Phase ............ 24 M od es .............. 29 Dot Clock ..........24 Appendix B: Aerial Connection ....29 Sound in PC mode ......... 24 Other Features ..........24 Appendix C: Connect Peripheral Equipment ............29 TV Status ............
DON’T place water filled vessels on top of T.V. Safety Precautions cabinets. Please read the following recommended safety pre- DON’T remove any fixed cover as this may ex- cautions carefully for your safety. pose dangerous voltages. IMPORTANT SAFETY DON’T leave equipment switched on when it is INFORMATION ON OPERATING unattended unless it is specifically stated that it YOUR TV...
circuit or electric shock.Never make a knot in the cord als, such as foil bag, must be kept away from chil- or tie it with other cord.The power cord should be dren. placed in such a way that they are not likely to be •...
Features Accessories • Remote controlled colour LCD TV. Check the supplied accessories before installation. In case of missing or damaged items please contact • Fully integrated Digital TV (DVB-T). your dealer immediatley. • 100 programmes from VHF, UHF bands or cable channels can be preset.
Rear View and Peripheral Connections Built in speakers. IR Receiver Standby LED Fixed table top stand. 220V-240V POWER AC~50 Hz S-VHS Input (S-Video) -P/CH+ SCART 1 (EXT-1) Video Input (FAV) -VOLUME+ SCART 2 (EXT-2) HDMI Input (HDMI1) Audio Inputs s STAND-BY For Service Use Only PC VGA Input (PC RGB)
Remote Control Buttons = Stand By YELLOW / FEATURE = Feature Menu/Fastext button BLUE / INSTALL = Install Menu/Fastext button = Update / No function = Hold SOUND PICTURE FEATURE INSTALL / GUIDE = Index Page GUIDE= Electronic Programme Guide (EPG) / PC = Reveal / PC WIDE GUIDE...
Preparation For ventilation, leave a space of at least 10 cm free all around the set. To prevent any fault and unsafe situa- tions, please do not place any objects on top of the set. Use this apparatus in moderate climates. Note: Remove the battery from remote control hand- set when it is not to be used for a long period.
Switching The TV ON/OFF Initial Settings To switch the TV on When the TV is turned on for the first time, it is in the digital mode. Your TV will switch on in two steps: Because this is the first time the TV is used, there are no 1- Connect the power supply cord to the system.
Basic Operations You can operate your TV using both the remote control and onset buttons. Operation with the buttons on the TV Country Volume Setting Language -” button to decrease volume or “ +” • Press “ TXT Language button to increase volume, so a volume level scale (slider) will be displayed at the middle of the bottom PLEASE CHECK ANTENNA CABLE on the screen.
Press directly the programme number to reselect single ing this button again you can close this window. digit programmes. Everyday Operation Pressing the “ ” button at any time while watch- Rolling national and international news including breaking news as it happens, ing television programmes will switch the TV set be- business updates, sports results and weather summaries.
Digital Teletext ule time. By pressing “YELLOW/BLUE” you can advance the schedule backward / forward of a With Digital terrestrial broadcasting (DVB-T), in addi- day. tion to pictures and sound, you can also watch digital • If you press “INFO” button you can see the detailed teletext.
IDTV Menu System To watch a specific channel, highlight it using button and then press “SELECT” button, while the The IDTV menu can only be shown when watching “SELECT” item on Channel List menu is highlighted by using button. Digital terrestrial broadcasting. Press the “ ”...
Setting Favourites You can set various channels as favourites so that CHANNEL LIST BBC ONE only the favourite channels are navigated. To set a 1. BBC ONE favourite you should highlight the “Favourites” item 2. BBC TWO at bottom of the Channel List menu. 3.
Page 16
This menu includes the following items: Please ensure aerial is plugged in. Do you 1. Add New Channels want to start first time installation? 2. First Time Installation. ADD NEW CHANNELS: Press the “OK” button to start installation. After search This tuning menu consists of two parts: is completed for digital channels, a message asking Automatic Search...
see the programme numbers and names assigned to and enables the automatic display of subtitles when- the programmes. ever subtitle information is broadcast. If you do not accept the locations and / or the Highlight the Subtitle line in the Configuration menu button to cycle through “Off”...
Timers Manual upgrade starts if the “Search for New Ver- sion” item is highlighted by using button and You can set a timer to switch the TV to any channel activated via pressing the “SELECT” button. without your intervention. This is also for making video After “Search for New Version”...
TV Setup • The channel name is set using the button to display the channel which broadcasts the To be able to go through TV functions, you can use programme. this item. • The start time, end time and date are each set with The digital TV Setup menu screen is accessed from the digit buttons on the remote control in 24-hour the main menu.
Analogue TV Menu System 1. Switch off the TV and unplug from the mains. 2. Insert the CAM, then Viewing Card to the slot that is Picture Menu located in the terminal cover at the left-hand side of the TV (from front view). •...
Picture Zoom sound mode button select Picture Zoom. By pressing By pressing button, select Sound Mode. Press buttons, to change picture zoom to Auto, button to change sound mode. 16:9, 4:3, Panaromic, 14:9 Zoom, Cinema, Sub- Sound mode is used to identify sound mode of the title, or Zoom.
Features Menu mode, connected device displays digital source. In order to avail this function, EXT-2 Output should be set to TV/DTV. PC Audio In select Pc Audio In.By pressing By pressing button, you can change the PC Audio In to TV, , FEATURE DTV, EXT-1, EXT-2, FAV, YPbPr Audio, PC Audio or FAV.
Install Menu gation buttons move the selected programme to the decided programme space and press the GREEN but- ton again. Delete To delete a programme, press the YELLOW button. INSTALL Pressing the YELLOW button again erases the se- lected programme from the programme list, and the Program Table programmes below shift one up.
enter a number via digit buttons on the remote control. Colour System There are 100 program storage between 0 and 99. select Colour System. By press- By pressing Band button, you can change the colour system to PAL, SECAM, PAL 60, NTSC 4,43, NTSC 3,58 or Band can be selected either “C”...
H (Horizontal) Position PC Mode This item shifts the image horizontally to right hand Installation side or left hand side of the screen. • Power off both Computer and Display before making • Select H Position item by using button. any connections.
Zoom Modes Subtitle Zoom mode can be changed by pressing the WIDE This zooms up the wide picture (16:9 aspect ratio) with subtitles to the full screen. button. You can change the screen size according to the picture aspect ratio. Select the optimum one from the following ZOOM modes.
Teletext Note: If the signal becomes insufficient, the teletext mode will be quitted. You can display Teletext information on your TV. Each Fastext channel which broadcasts teletext, transmits a page Your TV supports the 500 page Teletext system. When with information on how to use its teletext system the page number of any of the 500 pages in memory (usually page 100).
Connect Peripheral Equipment Then, press the “AV” button to select EXT1 or EXT2. Copy Facility High Definition Source selection for VCR recording. Your LCD Television is capable of displaying High • Select Feature menu. Definition pictures from devices such as a High Defi- •...
Tips Care Of The Screen Clean the screen with a slightly damp, soft cloth. Do not use abrasive solvents as they may damage the TV screen coating layer. Poor Picture Have you selected the correct TV system? Is your TV set or house aerial located too close to non-earthed audio equipment or neon lights, etc.? Mountains or high buildings can cause double pictures...
Appendix A: PC Input Typical Display Modes The display has a maximum resolution of 1360 x 768, frequency range of 56-75 Hz. The following table is an illustration of some of the typical video display modes. Resolution Frequency Mode Horizontal Vertical Hor.(kHz) Ver.(Hz) 31,5 37,9 37,5...
Specifications Signal Input PC RGB Terminal (D-sub 15-pin connector) Input signal G or sync on green • When different kinds of input signals are simul- No connection taneously input to the monitor via a graphics No connection board or the like, the monitor will automatically select the signals in the following priority order: R.GND G.GND...
Page 34
Product Guarantee This product is guaranteed against manufacturing defects for a period of 1 Year This does not cover the product where the fault is due to misuse, abuse, use in contravention of the instructions, or where the product has been the subject of unauthorised modifications or alterations, or has been the subject of commercial use In the event of a problem with the product within the guarantee period please return it to your nearest store If the item is shown to have had an inherent defect present at the time of sale, the store will provide you with a...
• It is recommended that a scart lead should be fitted between your TV and VCR to enhance your picture and sound quality. Scart leads are essential if you have a stereo TV and VCR and wish to obtain stereo sound from your equipment. These leads can be purchased from your Hitachi dealer or any good High Street electrical retailer.
Page 36
...or through a satellite decoder... TFT-LCD TV RF Lead from Satellite to TV Aerial • Scart Lead to EXT-1 on TV. ANT.IN RF Lead to Aerial Satellite LNB lead ...or through a VCR and satellite decoder. TFT-LCD TV RF Lead from •...
connect the TV plug to the mains socket UK plug European plug Power Cord Power on/off Input button ...and switch on insert plug... Plug the mains lead into the TV insert plug... switch your TV on by pressing the On/Off button NB: When the set is first switched on, the set will be in standby and the indicator on the front of the set will illuminate red...
important note before starting Auto Setup If you have a Video Cassette Recorder or a Satellite receiver connected to your TV please ensure that they are switched on before automatic tuning begins. In the case of a VCR, insert a pre-recorded tape and begin playback of your equipment. These measures ensure that all your external equipment is tuned in during the Auto Setup procedure.
Page 41
With your TV in digital TV mode, press ‘Menu’ on your remote control. From the menu options on screen, select ‘Installation’. Select ‘First Time Installation’ to re-tune your digital TV (not ‘Add New Channels’). If you do not re-tune your channels when advised to do so by Digital UK, you may lose some or all of your channels until you do re-tune.