Beeper Definitions - Motorola SYMBOL LS7708 Product Reference Manual

Beeper Definitions

The scanner communicates by emitting different beeper sequences.
scanning and while programming the scanner.
Beeper Sequence
Standard Use
3 short high beeps
Short high beep
4 long low beeps
5 low beeps
Lo/hi/lo beep
Hi/hi/hi/lo beep
Parameter Menu Scanning
Short high beep
Lo/hi beep
Hi/lo beep
Hi/lo/hi/lo beep
Lo/hi/lo/hi beep
Lo/lo/lo/lo beep
Code 39 Buffering
Hi/lo beep
3 long high beeps
Lo/hi/lo beep
Lo/hi beep
Host Specific
USB only
4 short high beeps
Scanner emits a power-up beep
sequence (3 short high beeps) after
scanning a USB Device Type.
This power-up beep occurs more
than once.
RS-232 Host only
1 short high beep
Table 2-1. Standard Beeper Definitions
Power up.
A bar code was decoded (if decode beeper is enabled).
A transmission error was detected in a scanned symbol. The data is ignored. This occurs if the scanner is not properly
configured. Check option settings.
When scanning bar code menu symbols, indicates the handheld scanner does not support the setting; use the primary
scanner instead.
Conversion or format error.
ADF transmit error.
RS-232 receive error on RS-232 host or RS-232 auxiliary port.
Correct entry scanned or correct menu sequence performed.
Input error, incorrect bar code or "Cancel" scanned, wrong entry, incorrect bar code programming sequence;
remain in program mode.
Keyboard parameter selected. Enter value using bar code keypad.
Successful program exit with change in the parameter setting.
Out of host parameter storage space. Scan
Unsupported parameter.
New Code 39 data was entered into the buffer.
Code 39 buffer is full.
The Code 39 buffer was erased or there was an attempt to clear or transmit an empty buffer.
A successful transmission of buffered data.
Scanner has not completed initialization. Wait several seconds and scan again.
Communication with the bus must be established before the scanner can operate at the highest power level.
The USB bus may put the scanner in a state where power to the scanner is cycled on and off more than once. This is
normal and usually happens when the PC cold boots.
A <BEL> character is received and Beep on <BEL> is enabled.
Table 2-1 defines beeper sequences that occur during normal
Indication
Set Default Parameter on page 4-5.
Scanning 2-5