Connecting To An Ibm 468X/469X Host - Motorola SYMBOL LS7708 Product Reference Manual

Hide thumbs Also See for SYMBOL LS7708:
Table of Contents

Advertisement

8-4
Symbol LS7708 Product Reference Guide

Connecting to an IBM 468X/469X Host

The scanner connects directly to an IBM host interface. This configuration requires an external power supply regardless of whether
peripherals are attached.
RS-232 Auxiliary Device
Host
Figure 8-1. IBM Connection - Power Supplied Externally, with or without Peripherals
1. Connect the interface cable to the host port of the scanner.
2. Connect the other end of the interface cable to the appropriate port on the host (typically, Port 9).
3. Connect the peripherals, if any, to their respective ports (see
4. Connect the power supply to the scanner's power port.
5. Scan the appropriate bar codes in this chapter or use 123Scan to configure the scanner.
Interface cables vary depending on configuration. The connectors may be different from the examples
illustrated, but the steps to connect the scanner are the same. See
information.
The only required configuration is the port number. The host system controls most other scanner parameters.
Note
Host Port
To EAS
(optional)
Figure
8-1).
Hand-Held Scanner
Power Supply
Chapter 1, Getting Started
for connection
Power Port

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents