Rs-232 Default Parameters - Motorola SYMBOL LS7708 Product Reference Manual

6-6 Symbol LS7708 Product Reference Guide

RS-232 Default Parameters

Table 6-1 lists the defaults for RS-232 host parameters. To change any option, scan the appropriate bar code(s) beginning in
Host Parameters on page 6-7.
Scanning parameter setting bar codes with the primary scanner also changes settings on the auxiliary
scanner.
Note
See Appendix A, Standard Default Parameters
miscellaneous default parameters.
Note
RS-232 Host Parameters
RS-232 Host Types
Baud Rate
Parity
Check Receive Errors
Hardware Handshaking
Software Handshaking
Host Serial Response Time-out
RTS Line State
Stop Bit Select
Data Bits
Beep on <BEL>
Intercharacter Delay
Nixdorf Beep/LED Option
Ignore Unknown Characters
1
User selection is required to configure this interface and this is the most common selection.
for all user preferences, hosts, symbologies, and
Table 6-1. RS-232 Host Default Table
Parameter Default Page Number
1
Standard 6-9
9600 6-13
None 6-17
Enable 6-20
None 6-21
None 6-24
2 Sec 6-26
Low RTS 6-29
1 6-30
8-Bit 6-31
Disable 6-32
0 msec 6-33
Normal Operation 6-35
Send Bar Codes 6-37
RS-232