Advertisement
Quick Links
MONARCH INSTRUMENT
Instruction Manual
ACT-1B, ACT-1B-10, ACT-1B-60
Panel Tachometers
15 Columbia Drive
Amherst, NH 03031-2334 USA
Printed in the U.S.A.
Phone: (603) 883-3390
© Monarch Instrument 2001 all rights reserved
Fax: (603) 886-3300
E-mail: techsup@monarchinstrument.com
1071-4842-114
Website: www.monarchinstrument.com
Advertisement
Related Manuals for Monarch ACT-1B-10
Summary of Contents for Monarch ACT-1B-10
- Page 1 MONARCH INSTRUMENT Instruction Manual ACT-1B, ACT-1B-10, ACT-1B-60 Panel Tachometers 15 Columbia Drive Amherst, NH 03031-2334 USA Printed in the U.S.A. Phone: (603) 883-3390 © Monarch Instrument 2001 all rights reserved Fax: (603) 886-3300 E-mail: techsup@monarchinstrument.com 1071-4842-114 Website: www.monarchinstrument.com...
-
Page 2: Limited Warranty
REGARDLESS OF WHETHER THE CLAIM IS BASED ON CONTRACT, TORT, STRICT product or Monarch Instrument directly. LIABILITY, OR OTHER THEORY OF LIABILITY. This limited warranty does not extend or apply to consumables (including, but not limited to, lamps and batteries, if applicable) or equipment, instruments or accessories which are warranted separately by the original manufacturer of these items. -
Page 3: Table Of Contents
Division of Monarch International Inc. Installation and Power ............ 2 15 Columbia Drive, Amherst NH 03031 USA Sensor Connections ............4 declares under Monarch’s sole responsibility that the product: Output Options ............... 6 Name: ACT - Panel Tachometer Models: ACT-1B, ACT-1B-10, ACT-1B-60 Options ................ -
Page 4: Specifications
8 Vdc at 5 mA for proximity sensors 5 Vdc at 75 mA for all other sensors Recommended Sensors: Optical - Monarch ROS-5W Proximity - Monarch P5-11 Magnetic - Monarch M-190W or MT-190W Infrared - Monarch IRS-5W Laser - Monarch RLS-5W... -
Page 5: Overview
OPTIONS OVERVIEW 4 to 20 mA current output ACT-1B Digital Tachometers display rotational speed directly in RPM on a 5 digit red LED display using a speed sensor providing a single pulse per 0 to 5 Vdc analog output revolution (Model ACT-1B), 10 pulses per revolution (Model ACT-1B-10) NOTE: Full scale RPM must be specified for the above or 60 pulses per revolution (Model ACT-1B-60). - Page 6 Installation Analog Output Option (AO) Remove the mounting clips, if fitted, and install the unit into the panel from The analog output is 0 to 5 Vdc. the front. From the rear of the unit, install the mounting clips on each side Connect the Positive side of the signal to the terminal marked OUT, and tighten the mounting screws against the rear of the panel.
-
Page 7: Sensor Connections
If the unit is dc powered, connect the dc supply Positive to the terminal marked L+ and the dc supply Negative or Common to the terminal marked N-. NOTE: On dc powered units, no connection is required to the terminal marked GND. -
Page 8: Options
Refer to Figure 3 for connection of Monarch standard sensors. The OUTPUT OPTIONS connections are typical for these types of sensors. The ACT-1B may be equipped with either a Current Output (IO) or an Analog Output (AO), and/or a TTL Pulse Output (PO).