Lincoln Electric Innershield NR-131 Datasheet

M A T E R I A L S A F E T Y D A T A S H E E T
Conforms to Hazard Communication Standard 29CFR 1910.1200 Rev. October 1988
Manufacturer/
The Lincoln Electric Company
Supplier:
22801 St. Clair Avenue
Cleveland, OH 44117-1199
(216) 481-8100
I M P O R T A N T !
This section covers the materials from which this product is manufactured. The fumes and gases produced during welding with the normal
use of this product are covered by Section V; see it for industrial hygiene information.
CAS Number shown is representative for the ingredients listed. All ingredients listed may not be present in all sizes.
(1) The term "hazardous" in "Hazardous Materials" should be interpreted as a term required and defined in the Hazards Communication
Standard and does not necessarily imply the existence of any hazard. All materials are listed on the TSCA inventory.
Ingredients:
Iron
Aluminum and/or aluminum alloys (as Al)*****
Fluorides (as F)
Magnesium and/or magnesium alloys and compounds (as Mg)
Limestone and/or calcium carbonate
Rare Earths
Magnesite
Silicon and/or silicon alloys and compounds (as Si)
Iron oxides
Manganese and/or manganese alloys and compounds (as Mn)*****
Carbon black
Carbon steel tube
Supplemental Information:
(*) Not listed. Nuisance value maximum is 10 milligrams per cubic
meter. PEL value for iron oxide is 10 milligrams per cubic meter.
TLV value for iron oxide is 5 milligrams per cubic meter.
(*****) Subject to the reporting requirements of Sections 311, 312, and 313 of
the Emergency Planning and Community Right-to-Know Act of 1986
and of 40CFR 370 and 372.
Non Flammable; Welding arc and sparks can ignite combustibles and flammable products. See Z49.1 referenced in Section VI.
Product is inert, no special handling or spill procedures required. Not regulated by DOT.
Rev 9/07
Date:
Trade Name:
Sizes:
Supersedes:
For Welding Consumables and Related Products
SECTION I - IDENTIFICATION
SECTION II - HAZARDOUS MATERIAL (1)
SECTION III - HAZARD DATA
3/1/2008
MSDS No.:
Innershield NR-131
All
2/1/2000
Product Type: Flux Cored Electrode
Classification: AWS E70T-10
CAS No. Wt.%
7439-89-6
7429-90-5
7789-75-5
7439-95-4
1317-65-3
68476-89-1
1309-48-4
7440-21-3
65996-74-9
7439-96-5
1333-86-4
7439-89-6
(c) Value is for manganese fume. Present PEL is 5
milligrams per cubic meter (ceiling value). Values
proposed by OSHA in 1989 were 1.0 milligrams per
cubic meter TWA and 3.0 milligrams per cubic meter
STEL (Short Term Exposure Limit).
(CONTINUED ON SIDE TWO)
US-CW110
TLV PEL
3
mg/m mg/m
< 5 10*
< 5 10
< 5 2.5
1 10*
1 10
0.5 10*
< 0.5 10
< 0.5 10*
< 0.5 5
< 0.5 0.2 5 (c)
< 0.5 3.5
85 10*
3
10*
15
2.5
10*
15
10*
15
10*
10
3.5
10*