Chamberlain 953EV Manual

For use with Chamberlain 315 MHz or 390 MHz garage door openers manufactured after
January 1, 1993. The garage door opener activates when the programmed button on the
remote control is pressed. The remote control can activate up to three garage door openers.
Make sure the garage door opener has a working light bulb because it is a programming
indicator.
GARAGE ACCESS SYSTEM
REMOTE
MODELS 953EV AND 953EVC
PREPARE
PROGRAM THE REMOTE CONTROL (953EV & 953EVC)
1
To enter
programming
mode, use the
visor clip to
press the Program
button until the LED
on the front of the
remote control turns on.
4
To exit programming mode, press
any remote control button except
the button that was just programmed.
LED
Learn
OR
LED
Green
or
Red/Orange
Purple
2
Press and
release the
Learn button
on the garage
door opener.
The Learn LED will light.
Within 30 seconds...
5
To test, press the programmed button on
the remote control...
MODELS 953EV, 953EVC, 956EV AND 956EVC
GARAGE ACCESS SYSTEM
KEYCHAIN REMOTE
MODELS 956EV AND 956EVC
LED
Locate the Learn
button on the garage
door opener.
NOTE: Your garage door
opener may look different.
OR
Learn
LED
Learn
LED
Yellow
3
Press and release the remote
control button you want to use...
Check to see if the garage door opener
light bulb blinks. If not, wait for the
remote control LED to light solid then
slowly press and release the remote
control button again. Repeat until the
light bulb blinks.
DO NOT press the button after the
light bulb blinks.
The garage door opener
will activate.
3-BUTTON REMOTE CONTROLS
To prevent possible SERIOUS INJURY or
DEATH from a moving gate or garage door:
• ALWAYS keep remote controls out of
reach of children. NEVER permit children
to operate or play with remote controls.
• Activate gate or door ONLY when it can be
seen clearly, is properly adjusted and there
are no obstructions to door travel.
• ALWAYS keep gate or garage door in sight
until completely closed. NEVER permit
anyone to cross path of moving gate or
door.
Locate the Program button on the
remote control.
953EV &
953EVC
956EV &
956EVC
6
Install the visor clip.
Program Button
Program Button