Error Messages - Yamaha RX-V473 Owner's Manual

Hide thumbs Also See for RX-V473:
Table of Contents

Advertisement

1 2 3 4 5 6 7 8 9 10
Automatic speaker setup

Error messages

If any error message is displayed during the measurement, resolve the problem and perform YPAO again.
A u t o S e t u p
ERROR
E-5:Noisy
S t a r t
E x i t
PROCEED
5 %
TV screen
VOL.
E-5:NOISY
Front display
Procedure to handle errors
1
Check the content of error message and
press ENTER.
2
Use the cursor keys (e/r) to select the
desired operation.
To exit the YPAO measurement:
a Select "EXIT" and press ENTER.
b Use the cursor keys (q/w) to select "Exit" and press
ENTER.
c Disconnect the YPAO microphone from the unit.
To retry the YPAO measurement from
beginning:
Select "RETRY" and press ENTER.
To proceed with the current YPAO
measurement (for E-5 and E-9 only):
Select "PROCEED" and press ENTER.
Error message
E-1:No Front SP
Error
(E-1:NO FRNT SP)
message
E-2:No Sur. SP
(E-2:NO SUR SP)
E-4:SBR → SBL
(E-4:SBR → SBL)
E-5:Noisy
(E-5:NOISY)
E-6:Check Sur.
SW
C
L
R
SL
SR
(E-6:CHECK SUR)
E-7:No MIC
(E-7:NO MIC)
E-8:No Signal
(E-8:NO SIGNAL)
E-9:User Cancel
(E-9:CANCEL)
E-10:Internal Err.
(E-10:INTERNAL)
• Texts in parentheses denote indicators on the front display.
Cause
Front speakers are not detected.
One of the surround speakers cannot be
detected.
A surround back speaker is connected to
the R side only.
The noise is too loud.
Surround back speakers are connected,
but no surround speakers are connected.
The YPAO microphone has been removed.
The YPAO microphone cannot detect test
tones.
The measurement has been canceled.
An internal error has occurred.
PREPARATIONS ➤ Optimizing the speaker settings automatically (YPAO)
Remedy
Exit YPAO, turn off the unit, and then check the speaker
connections.
When using only one surround back speaker, you need to
connect it to the SINGLE jack (L side). Exit YPAO, turn off the
unit, and then reconnect the speaker.
Keep the room quiet and retry YPAO. If you select
"PROCEED", YPAO takes the measurement again and
ignores any noise detected.
Surround speakers need to be connected in order to use
surround back speakers. Exit YPAO, turn off the unit, and
then reconnect the speakers.
Connect the YPAO microphone to the YPAO MIC jack firmly
and retry YPAO.
Connect the YPAO microphone to the YPAO MIC jack firmly
and retry YPAO. If this error occurs repeatedly, contact the
nearest authorized Yamaha dealer or service center.
Retry or exit YPAO as necessary.
Exit YPAO, and turn off and on the unit. If this error occurs
repeatedly, contact the nearest authorized Yamaha dealer or
service center.
32
En

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rx-v573blRx-v573Rx-v473bl

Table of Contents