Connections To Other Equipment - Sansui HDPDP5050 Owner's Manual

Connections to other equipment

The exact arrangement you use to interconnect various video and audio components to the Plasma TV is
dependent on the model and features of each component. Check the Owner's Manual provided with each
component for the location of video and audio inputs and outputs.
The connection diagrams below are offered as suggestions. You may need to modify them to accommodate
your particular assortment of components. The diagrams are intended to show component video and audio
interconnections only.
To connect the Plasma TV to a VCR
Rear lower of the Plasma TV
To AUDIO/VIDEO IN 1 (or 2)
Audio/Video cord (not supplied)
To Audio/Video OUT
To connect the Plasma TV to a VCR with an S-Video cord
If you connect a VCR with a S-VIDEO cord to the S-VIDEO IN jack on the rear of the Plasma TV, you must also
connect the audio cords to the AUDIO IN jacks on the rear of the Plasma TV. The S-VIDEO cord only carries the
video signal. The audio signal is separate.
Rear lower of the Plasma TV
To S-VIDEO IN 1 (or 2)
To S-Video OUT
To AUDIO
IN 1 (or 2)
S-Video cord (not supplied)
Audio cord (not supplied)
To Audio OUT
NOTE:
When the S-video cord and the video cord are connected to each jack at the same time, the S-video cord takes
precedence over the video cord.
16