Inserting A Program To The Chain Play List - Fostex VF160 Supplement Owner's Manual

Inserting a program to the chain play list

You can insert a program to a desired step in the current chain play list.
1) Follow procedure steps 1) and 2) on page 11 to show the "Chain Play List" screen.
(i.e. enter the setup mode and select "Chain Play List".)
2) Use the [JOG] dial to select a step where you want to add a program and press the
[ENTER/YES] key.
The program number set to the selected step starts flashing. If you select "C02" on the left
screen example below, "P02" starts flashing.
3) Use the [JOG] dial to select "INS" and press the [ENTER/YES] key.
You can now select a program to be inserted. Initially, "P01" flashes.
As you can see by comparing the two screen examples above, the programs set to the
second and subsequent steps slide down automatically.
4) Use the [JOG] dial to select a program to be inserted, and press the [ENTER/YES]
key.
In the example shown below, program 6 (P06) is inserted to step 2.
If you want to insert a program to another step, repeat the same procedure above.
<Note>
You can enter up to 99 programs to the play list. If you are trying to enter a pro-
gram to the play list where 99 programs are already registered, "Void! Play List is
Full" is shown and the operation is canceled.
5) After inserting all desired programs, press the [EXIT/NO] key.
The "Chain Play List" screen is dismissed and the display returns to the "Select Menu"
screen where the current option of the "Chain Play" mode setting is flashing.
<Note>
If you insert the desired program(s) to the chain play list when the "Chain Play"
mode is set to any option but "Off", the "Chain Play" setting automatically changes
to "Off" (the default).
Therefore, to execute chain play after editing the chain play list, you must set the
"Chain Play" mode appropriately again.
6) After setting the "Chain Play" mode appropriately, press the [EXIT/NO] key
repeatedly until exiting the setup mode.
VF160 Owner's Manual <V2.0 Supplement>
13