Deleting All Programs From The Chain Play List - Fostex VF160 Supplement Owner's Manual

VF160 Owner's Manual <V2.0 Supplement>

Deleting all programs from the chain play list

You can delete all the program in the chain play list simultaneously.
1)
2)
3)
4)
<Note>
If you delete or replace a program in the chain play list when "Chain Play" is set to
any option but "Off", the "Chain Play" setting automatically changes to "Off" (which
is the default). Therefore, to execute chain play after editing the chain play list,
you must make the "Chain Play" mode setting appropriately again.
Follow procedure steps 1) and 2) on page 11 to show the "Chain Play List" screen.
(i.e. enter the setup mode and select "Chain Play List".)
While step 1 (C01) is highlighted (selected), press the [ENTER/YES] key.
The program number set to step 1 (P01) starts flashing.
If step 1 ("C01") is not highlighted, use the [JOG] dial to select step 1 and press the [ENTER/
YES] key.
Use the [JOG] dial to select "END" and press the [ENTER/YES] key.
All the programs in the list are deleted at once and the screen shows as below
("C01: END" is shown in the chain play list, which means no program is entered to the list).
<Note>
If you select any step but "C01" in procedure step 2) above and follow procedure
step 3), programs set to the selected and subsequent steps are deleted from the
list.
For example, if you set "END" to step 3 (C03) in the chain play list where ten steps
are currently set, programs set to steps 3 through 10 are all deleted, while programs
set to steps 1 and 2 remain.
Press the [EXIT/NO] key repeatedly until the setup mode exits.
The "Chain Play" mode setting is automatically changed to "Off".
12