Selecting A Program In The Chain Play List - Fostex VF160 Supplement Owner's Manual

VF160 Owner's Manual <V2.0 Supplement>
<Notes on playing back the chain play list>
When the play mode is set to any option but "Off", the recorder immediately locates to
the start point of the program set to step 1 (C01) in the play list, and then stops.
If you move the recorder to a position out of the range between the Auto Return Start
and End points (or after the REC END point), "Out of Zone" is shown instead of the step
number. In such a condition, the recorder does not correctly execute chain play. The
worst case is that you start chain play when the recorder position is after the Auto
Return End point (or the REC END point). The recorder never moves to the next program.
To move the recorder to the start point of a program, reselect a program you want to
start chain play from by following the procedure described below.

Selecting a program in the chain play list

If the play mode is set to any option but "Off", you can select a program only
from those set to the chain play list. By selecting a program, you can start chain
play from the desired step in the chain play list.
In the following procedure, it is assumed that the chain play list has been made,
the play mode is set to an option but "Off", and the program set to the first step
of the chain play list is loaded.
<Note>
If you want to select any program on the disk, as usual, turn off the power and then on,
or set the chain play mode to "Off" (see "Setting the chain play mode").
1)
2)
As described above, by selecting a program while the chain play mode is set to any
option but "Off", you can start chain play from the desired program.
While the recorder is stopped, press the [PGM SEL] key.
After showing "Select Change No!" immediately, the display changes to show the screen as
below, on which the current program list number and "Sure?" flash.
In this condition, you can select another program set in the list by rotating the [JOG] dial.
Use the [JOG] dial to select the desired step and press the [ENTER/YES] key.
The program set to the selected step is loaded and the recorder is stopped at the beginning
of the program (ABS 0), while the display shows the Normal screen.
In the screen examples below, program 4 (P04) set to step 4 (C04) is selected.
flashing
10